Manualsbrain.com
  1. Manuals
  2. Brands
  3. Sony
  4. CDX-GT63UIW
  5. User Manual

Sony CDX-GT63UIW User Manual

Download
Page of 80
22
D:\Documents and Settings\takashi-
shimomura\Desktop\0710_4Delivery\ML\4113865311\01US02CD-U.fm
masterpage:Left
CDX-GT630UI/GT63UIW
4-113-865-31 (1)
General
Outputs: 
Audio outputs terminal (front/rear)
Subwoofer output terminal (mono)
Power antenna (aerial) relay control terminal
Power amplifier control terminal
Inputs: 
Remote controller input terminal
Antenna (aerial) input terminal
Telephone ATT control terminal
Illumination control terminal
BUS control input terminal
BUS audio input terminal
AUX input jack (stereo mini jack)
USB signal input terminal
Tone controls: 
Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at 1 kHz (XPLOD)
High: ±10 dB at 10 kHz (XPLOD)
Power requirements: 12 V DC car battery 
(negative ground (earth))
Power supply voltage: 11 – 16 V
Dimensions: Approx. 178 
× 50 × 182 mm 
(7
1
/
8
 
× 2 × 7
1
/
4
 in) (w/h/d)
Mounting dimensions: Approx. 182 
× 53 × 162 mm 
(7
1
/
4
 
× 2
1
/
8
 
× 6
1
/
2
 in) (w/h/d)
Mass: Approx. 1.3 kg (2 lb 14 oz)
Supplied accessories: 
Card remote commander: RM-X151
Parts for installation and connections (1 set)
Optional accessories/equipment: 
Rotary commander: RM-X4S
BUS cable (supplied with an RCA pin cord): 
RC-61 (1 m), RC-62 (2 m)
CD changer (10 discs): CDX-757MX
CD changer (6 discs): CDX-T69
Source selector: XA-C40
AUX-IN selector: XA-300
USB connection cable for iPod: RC-100IP
HD Radio
TM
 tuner: XT-100HD
Your dealer may not handle some of the above listed 
accessories. Please ask the dealer for detailed 
information.
Design and specifications are subject to change 
without notice.
Troubleshooting
The following checklist will help you remedy 
problems you may encounter with your unit.
Before going through the checklist below, check the 
connection and operating procedures.
If the problem is not solved, visit the following 
support site.
•  Halogenated flame retardants are not used in the 
certain printed wiring boards.
•  Halogenated flame retardants are not used in 
cabinets.
•  Packaging cushions are made from paper.
General
No power is being supplied to the unit.
• Check the connection or fuse.
• If the unit is turned off and the display disappears, it 
cannot be operated with the remote commander. 
t Turn on the unit.
The power antenna (aerial) does not extend.
The power antenna (aerial) does not have a relay box.
No sound.
• The ATT function is activated, or the Telephone ATT 
function (when the interface cable of a car telephone 
is connected to the ATT lead) is activated.
• The position of the fader control “FAD” is not set for 
a 2-speaker system.
No beep sound.
• The beep sound is canceled (page 16).
• An optional power amplifier is connected and you are 
not using the built-in amplifier.
The contents of the memory have been erased.
• The RESET button has been pressed.
t Store again into the memory.
• The power supply lead or battery has been 
disconnected or it is not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition 
is switched.
The leads are not matched correctly with the car’s 
accessory power connector.
During playback or reception, demonstration 
mode starts.
If no operation is performed for 5 minutes with 
“DEMO-ON” set, demonstration mode starts.
t Set “DEMO-OFF” (page 16).
The display disappears from/does not appear 
in the display window.
• The dimmer is set “DIM-ON” (page 17).
• The display disappears if you press and hold (OFF).
t Press and hold (OFF) on the unit until the 
display appears.
• The connectors are dirty (page 21).
Support site
http://esupport.sony.com
http://www.sony.com/xplod