Sony CDX-GT330 User Manual

Mass: Approx. 1.2 kg (2 lb 11 oz)
Supplied accessories:

Card remote commander: RM-X151
(CDX-GT330/GT33W/GT230 only)
Parts for installation and connections (1 set)

Optional accessories/equipment:

for CDX-GT330/GT33W

BUS cable (supplied with an RCA pin cord):
RC-61 (1 m), RC-62 (2 m)
CD changer (10 discs): CDX-757MX
CD changer (6 discs): CDX-T69
Source selector: XA-C40
AUX-IN selector: XA-300
Interface adaptor for iPod: XA-120IP
HD Radio™ tuner: XT-100HD

Your dealer may not handle some of the above listed
accessories. Please ask the dealer for detailed
information.

Design and specifications are subject to change
without notice.

Troubleshooting

The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check the
connection and operating procedures.

MPEG Layer-3 audio coding technology and
patents licensed from Fraunhofer IIS and Thomson.

This product is protected by certain intellectual
property rights of Microsoft Corporation. Use or
distribution of such technology outside of this
product is prohibited without a license from
Microsoft or an authorized Microsoft subsidiary.

• Halogenated flame retardants are not used in the

certain printed wiring boards.

• Halogenated flame retardants are not used in

cabinets.

• Packaging cushions are made from paper.

General

No power is being supplied to the unit.

• Check the connection. If everything is in order, check

the fuse.

• If the unit is turned off and the display disappears, it

cannot be operated with the remote commander.*

t Turn on the unit.

The power antenna (aerial) does not extend.

The power antenna (aerial) does not have a relay box.

No sound.

• The volume is too low.
• The ATT function is activated.
• The position of the fader control “FAD” is not set for

a 2-speaker system.

• The CD changer is incompatible with the disc format

(MP3/WMA).*

t Play back with a Sony MP3 compatible CD

changer, or this unit.

No beep sound.

• The beep sound is canceled (page 9).
• An optional power amplifier is connected and you are

not using the built-in amplifier.

The contents of the memory have been erased.

• The RESET button has been pressed.*

t Store again into the memory.

• The power supply lead or battery has been

disconnected.

• The power supply lead is not connected properly.

Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
is switched.

The leads are not matched correctly with the car’s
accessory power connector.

During playback or reception, demonstration
mode starts.

If no operation is performed for 5 minutes with
“DEMO-ON” set, demonstration mode starts.
t Set “DEMO-OFF” (page 9).

The display disappears from/does not appear
in the display window.

• The dimmer is set “DIM-ON” (page 9).
• The display disappears if you press and hold (OFF).

t Press and hold (OFF) on the unit until the

display appears.

• The connectors are dirty (page 13).

The Auto Off function does not operate.

The unit is turned on. The Auto Off function activates
after turning off the unit.
t Turn off the unit.

continue to next page