Sony cfs-b7lmk2 User Manual

I

I

220-
240V

110-
127V

VOLTAGE

SELECTOR

• Frequency range

CFS-B7SMK2

FM:

Saudi Arabia 87.6–107 MHz
Other countries 87.6–108 MHz

MW: 530–1,605 kHz
SW1: 2.3–7 MHz
SW2: 7–22 MHz

CFS-B7LMK2

FM: 65.0–108 MHz
MW: 531–1,602 kHz
LW: 153–279 kHz
SW: 5.95–18 MHz

• Aerials

FM/SW: Telescopic aerial
MW/LW : Built-in ferrite bar

• Recording system

2–track, 4–channel stereo

• Frequency response

70–10,000 Hz

• Speakers

Full range: 10 cm (4 inches) dia.,
2.8 ohms cone type x 2

• Output

Headphones jack (stereo minijack),
for 16–68 ohms impedance
headphones

• Maximum Power output

2.5 W+2.5 W

• Battery life

FM Recording: Sony R20P:

Approx. 16 hours/Sony LR20
alkaline: Approx. 36 hours

Playback:  Sony R20P: Approx.

8 hours/Sony LR20 alkaline:
Approx. 21 hours

• Power requirements

CFS-B7SMK2

110–127 V/220–240 V AC
selectable, 50/60 Hz

CFS-B7LMK2

230 V AC, 50 Hz

9 V DC, six R20 (size D)
batteries

• Power consumption

AC 14W

• Dimensions

Approx. 500 x 155 x 164 mm
(w/h/d) ( 19 

3

/

4

 x 6 

1

/

8

 x 6 

1

/

2

inches) incl. projecting parts and
controls, not incl. handle

Approx. 2.7 kg (5 lb 15 oz) not
incl. batteries

Mains lead (1)

Design and specifications are
subject to change without notice.

Sony Corporation © 1998

3-865-191-13(1)

Operating Instructions

Connect the supplied mains lead to the AC IN jack.

To prevent fire or shock hazard,
do not expose the player to rain
or moisture.
To avoid electrical shock, do not
open the cabinet. Refer servicing
to qualified personnel only.

Do not install the appliance in a
confined space, such as a
bookcase or built-in cabinet.

To prevent fire or shock hazard,
do not place objects filled with
liquids, such as vases, on the
appliance.

The FUNCTION selector is
located at the top panel.
When you turn on the player, the
OPR/BATT indicator lights up.

• Should any solid object or liquid

fall into the player, unplug the
player and have it checked by
qualified personnel before
operating it any further.

• For AC operation, check that the

player’s operating voltage is
identical with your local power
supply (see “Specifications”) and
use the supplied mains lead; do
not use any other type. The voltage
selector is located at the rear of the
player. (CFS-B7SMK2 only)

• The player is not disconnected

from the AC power source (mains)
as long as it is connected to the
mains, even if the player itself has
been turned off.

• For battery operation, use six R20

(size D) batteries.

• When the batteries are not to be

used, remove them to avoid
damage that can be caused by
battery leakage or corrosion.

• The nameplate indicating

operating voltage, power
consumption, etc., is located on the
bottom.

• Connect the mains lead

securely.

• Insert the batteries properly.
• Replace all the batteries if they

are weak.

• Unplug the headphones.
• Adjust the volume.
• Set FUNCTION to the position

you want to operate.

• Insert the cassette properly.
• Press 

p6 STOP/EJECT to

release.

r REC button does

• No cassette in the tape

compartment.

• Make sure the safety tab on the

cassette is in place.

• Dirty heads. Clean the unit (as

shown) with a cotton swab
slightly moistened with
cleaning fluid or alcohol.

• Demagnetize the heads and all

metal parts in the tape path
with a commercially available
head demagnetizer.

Tip
For customers supplied with an AC plug adaptor, use it if the plug
of the mains lead does not match your mains.

Notes
• To use the player on batteries, disconnect the mains lead from

the player.

• Replace the batteries when the OPR/BATT indicator dims or

when the player stops operating. Replace all the batteries with
new ones.

Insert six R20 (size D) batteries (not supplied) into the battery
compartment.

Be sure to set the VOLTAGE
SELECTOR (at the rear) to your local
power supply.

to AC IN

to the mains

• Do not leave the player in a

location near heat sources, or in
a place subject to direct sunlight,
excessive dust or mechanical
shock.

• Do not place anything within 10

mm of the side of the cabinet.  The
ventilation holes must be
unobstructed for the player to
operate properly and to prolong
the life of its components.

• Since a strong magnet is used for

the speakers, keep personal credit
cards using magnetic coding or
spring-wound watches away from
the player to prevent possible
damage from the magnet.

• If the player has not been used for

a long time, set it in the playback
mode to warm it up for a few
minutes before inserting a
cassette.

If you have any questions or
problems concerning your player,
please consult your nearest Sony
dealer.