Sony CMT-SE1 User Manual
O
p
ti
onal
Comp
onen
ts
15
GB
Listening to a connected MD
deck
deck
1
Connect the audio cord.
2
Press MD (TAPE) (or FUNCTION on the
unit) repeatedly until “MD” appears.
unit) repeatedly until “MD” appears.
Start playing the connected component.
Listening to a connected tape
deck
deck
1
Connect the audio cord.
2
Press MD (TAPE) (or FUNCTION on the
unit) repeatedly until “TAPE” appears.
unit) repeatedly until “TAPE” appears.
Hold down FUNCTION on the unit and
press ?/1 on the unit. This switches the
MD function to TAPE. Once you enable the
TAPE function, just press MD (TAPE).
press ?/1 on the unit. This switches the
MD function to TAPE. Once you enable the
TAPE function, just press MD (TAPE).
Tip
If you cannot select “MD” by pressing MD (TAPE)
(or
FUNCTION
on the unit) repeatedly, turn off the
system and then press ?/1 on the unit while holding
down FUNCTION on the unit. The function will
change from “TAPE” to “MD”, and “MD” will appear
in the display. To change back to “TAPE”, repeat the
same procedure. However, you cannot switch the MD/
TAPE function in Power Saving Mode.
down FUNCTION on the unit. The function will
change from “TAPE” to “MD”, and “MD” will appear
in the display. To change back to “TAPE”, repeat the
same procedure. However, you cannot switch the MD/
TAPE function in Power Saving Mode.
Making an analog recording
1
Connect the audio cord.
2
Start recording.
Refer to the operating instructions provided
with connected component.
with connected component.
Making a digital recording
1
Connect the digital optical cable.
2
Start recording.
Refer to the operating instructions provided
with connected component.
with connected component.
Note
You can digitally record from the discs only. However,
you cannot record from copy prohibited discs.
you cannot record from copy prohibited discs.
Listening to audio from a
connected component
connected component
Recording on a connected
component
component