Sony cmt-sd3 User Manual
27
Additional Information
Tuner
Severe hum or noise (“TUNED” or
“STEREO” flashes in the display).
“STEREO” flashes in the display).
•Adjust the aerial.
•The signal strength is too weak. Connect
•The signal strength is too weak. Connect
an external aerial.
•Make sure the aerial is connected
properly.
•Make sure the aerial is not folded or
rolled up.
•The AM aerial wire is detached from the
stand.
A stereo FM programme is not received in
stereo.
stereo.
•Press STEREO/MONO so “STEREO”
appears.
Periodic noise during MD recording.
•Adjust the aerial.
If other problems not described
above occur, reset the system as
follows:
above occur, reset the system as
follows:
1 Unplug the mains lead.
2 Hold down
2 Hold down
1/u, then plug the mains lead
into the wall outlet again.
The system is reset to the factory settings. All
the settings you made, such as the preset
stations, clock, and timer are cleared. You
should set them again.
the settings you made, such as the preset
stations, clock, and timer are cleared. You
should set them again.
Messages
One of the following messages may appear or
flash in the display window during
operation.
flash in the display window during
operation.
TUNER
Name Full
The system has stored the maximum
number of characters to be input.
number of characters to be input.
CD
Name Full
There is no more space to store track titles
or disc titles.
or disc titles.
OVER
You have reached the end of the CD while
pressing
pressing
) during pause.