Sony CPD-100GS

2

The model and serial numbers are located at the rear of the unit.
Record the serial number in the space provided below. Refer to
these numbers whenever you call upon your dealer regarding this
product.

Model No.

Serial No.

This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment.

According to 47CFR Parts 2 and 15 for

Trade Name:

Sony

Model No.:

CPD-100GS and CPD-200GS

Responsible Party:

Sony Electronics Inc.

Address:

1 Sony Drive, Park Ridge,
NJ. 07656

Telephone No.:

201-930-6970

This device complies with Part 15 of the FCC Rules. Each product
marketed, is identical to the representative unit tested and found
to be compliant with the standards. Records maintained continue
to reflect the equipment being produced can be expected to be
within the variation accepted, due to quantity production and
testing on a statistical basis. Operation is subject to the following
two conditions:  (1) This device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that cause undesired operation.

•

Aus ergonomischen Gründen wird empfohlen, die
Grundfarbe Blau nicht auf dunklem Untergrund zu
verwenden (schlechte Erkennbarkeit, Augenbelastung bei zu
geringem Zeichenkontrast).

•

Aus ergonomischen Gründen (flimmern) sollten nur
Darstellungen bei Vertikalfrequenzen ab 70 Hz (ohne
Zeilensprung) verwendet werden.

•

Die Konvergenz des Bildes kann sich auf Grund des
Magnetfeldes am Ort der Aufstellung aus der korrekten
Grundeinstellung verändern. Zur Korrektur empfiehlt es sich
deshalb, die Regler an der Frontseite für Konvergenz so
einzustellen, daß die getrennt sichtbaren Farblinien für Rot,
Grün und Blau bei z.B. der Darstellung eines Buchstabens zur
Deckung (Konvergenz) gelangen.
Siehe hierzu auch die Erklärungen zu Konvergenz.

This notice is applicable for USA/Canada only.
If shipped to USA/Canada, install only a UL LISTED/CSA
LABELLED power supply cord meeting the following
specifications:
SPECIFICATIONS

Plug Type

Nema-Plug 5-15p

Cord

Type SVT or SJT, minimum 3 

×

 18 AWG

Length

Maximum 15 feet

Rating

Minimum 7 A, 125 V

Cette notice s’applique aux Etats-Unis et au Canada
uniquement.
Si cet appareil est exporté aux Etats-Unis ou au Canada,
utiliser le cordon d’alimentation portant la mention UL
LISTED/CSA LABELLED et remplissant les conditions
suivantes:
SPECIFICATIONS

Type de fiche

Fiche Nema 5-15 broches

Cordon

Type SVT ou SJT, minimum 3 

×

 18 AWG

Longueur

Maximum 15 pieds

Tension

Minimum 7 A, 125 V

As an 

E

NERGY 

S

TAR Partner, Sony

Corporation has determined that this
product meets the 

E

NERGY 

S

TAR

guidelines for energy efficiency.