Sony dav-hdz485 User Manual

Page of 104
Contr
o
l f
o
r HDMI/
Extern
al A
u
dio 
D
e
vic
e
67
US
Note
• When you turn the system off while “S-AIR STBY” 
is set to “STBY ON,” “S-AIR” flashes (when sound 
transmission between the unit and S-AIR receiver is 
not established), or lights up (when sound 
transmission between the unit and S-AIR receiver is 
established) in the front panel display.
It is easy to set the same ID for the unit and an 
S-AIR sub unit, such as a surround amplifier or 
S-AIR receiver, to establish sound transmission. 
However, neighbors may also receive your 
system’s sound if IDs are the same, or you may 
receive sound from neighbors. To prevent this, 
you can identify the unit with a specific S-AIR 
sub unit by performing the pairing operation.
Before pairing
Sound transmission is established by ID 
(example).
After pairing
Sound transmission is established between the 
paired unit and S-AIR sub unit(s) only.
To perform pairing
1
Place the S-AIR sub unit that you want 
to pair near the unit.
Note
• Remove headphones from the surround 
amplifier (if connected).
2
Match the IDs of the unit and the S-AIR 
sub unit.
• To set the ID of the unit, see “To set the ID 
• To set the ID of the S-AIR sub unit, refer 
to the operating instructions of the S-AIR 
sub unit.
3
Press SYSTEM MENU.
4
Press 
X/x repeatedly until “PAIRING” 
appears in the front panel display, then 
press  
or 
c.
Note
• When the wireless transmitter is not inserted in 
the unit, “PAIRING” cannot be selected.
5
After “START” appears in the front 
panel display, press 
.
The unit starts pairing and “SEARCH” 
flashes in the front panel display.
To cancel pairing, press SYSTEM MENU.
Identifying the unit with a 
specific S-AIR sub unit 
(Pairing operation)
For the surround amplifier
For the S-AIR receiver
This unit
ID A
ID A
S-AIR sub unit
ID A
S-AIR sub unit
Your room
Neighbor
This unit
ID A
S-AIR sub unit
ID A
ID A
S-AIR sub unit
Your room
Neighbor
Pairing
No transmission