Sony 3-285-995-11(1) User Manual

X/x to select the output method 

• [VIDEO]: outputs video signals.
• [RGB]: outputs RGB signals.

• If your TV does not accept RGB signals, no 

picture appears on the TV screen even if you 
select [RGB]. Refer to the operating instructions 
supplied with your TV.

The Setup Display for selecting the speaker 
formation appears.

C/c to select the speaker 

For details, see “Getting Optimal Surround 
Sound for a Room” (page 81).

Set up the calibration mic at the ear level 
using a tripod, etc. (not supplied). The front 
of each speaker should face the calibration 
mic, and there should be no obstruction 
between the speakers and the calibration 
mic.

C/c to select [YES].

• Make sure that the headphones are not 

connected to the unit or surround amplifier. You 
cannot operate following Steps with the 
headphones connected.

[AUTO CALIBRATION] starts.
Be quiet during the measurement.

• Loud test sound is output when [AUTO 

CALIBRATION] starts. You cannot turn the 
volume down. Give consideration to children 
and neighbors.

• Before [AUTO CALIBRATION], install the 

surround amplifier in the appropriate location. If 
you install the surround amplifier in an improper 
location, such as another room, proper 
measurement will not be obtained.

• Avoid being in the measurement area and 

making noise during the measurement (which 
takes about 3 minutes), as it may interfere with 
measurement.

SPEAKER FORMATION

STANDARD

AUDIO IN / A.CA

L MIC

Calibration mic