Sony DDM-2801CU User Manual

14

1

These connectors are used for inputting the R (red), G
(green) and B (blue) signals. The connectors are
terminated at 50 ohms.

2

This connector is used when adjusting uneven color by
connecting the optional landing sensor DDM-LS10.

3

This I/F (interface) connector is used when externally
adjusting distortion, convergence, color temperature,
etc. by connecting the optional Remote controller DDM-
RM10.

4

Set this circuit breaker to the I (on)
position when using this unit.

5

This connector is used for inputting horizontal drive
pulses (HD). The connector is terminated at 75 ohms.

6

This connector is used for inputting vertical drive pulses
(VD). The connector is terminated at 75 ohms.

7

This indicator lights when the POWER switch on the
front panel is turned on.

8

This indicator lights when the circuits inside the unit are
not functioning correctly. Should this lamp light up, turn
off the MAIN circuit breaker and consult Sony
representative.

9

This control adjusts the picture rotation. Use a
screwdriver etc. to turn the control.

0

Connect an AC power cord here.

Note
When connecting to 

1

, 

5

 and 

6

, use a double-shielded coaxial

cable.

Rotate the picture
clockwise

Rotate the picture
counterclockwise