Sony dhc-md500 User Manual
44
AUDIO POWER SPECIFICATIONS:
(DHC-MD500 U.S.A. models only)
(DHC-MD500 U.S.A. models only)
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
HARMONIC DISTORTION:
with 6 ohm loads both channels driven, from
70-20,000 Hz; rates 60 watts per channel
minimum RMS power, with no more than
0.9% total harmonic distortion from 250
milliwatts to rated output.
70-20,000 Hz; rates 60 watts per channel
minimum RMS power, with no more than
0.9% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
DHC-MD500:
Continuous RMS power output (reference)
Continuous RMS power output (reference)
60 + 60 watts
(6 ohms at 1 kHz,
10% THD)
(6 ohms at 1 kHz,
10% THD)
Total harmonic distortion less than 0.07%
(6 ohms at 1 kHz, 45 W)
DHC-RX707:
DIN power output (rated) 60 + 60 watts
DIN power output (rated) 60 + 60 watts
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (reference)
80 + 80 watts
(6 ohms at 1 kHz,
10% THD)
(6 ohms at 1 kHz,
10% THD)
Music power output (reference)
135 + 135 watts
(6 ohms at 1 kHz,
10% THD)
(6 ohms at 1 kHz,
10% THD)
Inputs
MD/VIDEO IN:
MD/VIDEO IN:
voltage 450 mV/250 mV,
(phono jacks)
impedance 47 kilohms
MIX MIC: (phone jack)
sensitivity 1 mV,
impedance 10 kilohms
impedance 10 kilohms
Outputs
MD/VIDEO OUT:
MD/VIDEO OUT:
voltage 250 mV
(phono jacks)
impedance 1 kilohms
PHONES:
accepts headphones of 8
(stereo phone jack)
ohms or more
SPEAKER:
accepts impedance of 6 to
16 ohms
16 ohms
SUPER WOOFER:
(DHC-MD500 only):
(DHC-MD500 only):
Voltage 1 V, impedance 1
kilohm
kilohm
Specifications
Tape player section
Recording system
4-track 2-channel stereo
Frequency response
40 – 13,000 Hz (±3 dB),
(DOLBY NR OFF)
using Sony TYPE I
cassette
40 – 14,000 Hz (±3 dB),
using Sony TYPE II
cassette
cassette
40 – 14,000 Hz (±3 dB),
using Sony TYPE II
cassette
Wow and flutter
±0.15% W.Peak (IEC)
0.1% W.RMS (NAB)
±0.2% W.Peak (DIN)
0.1% W.RMS (NAB)
±0.2% W.Peak (DIN)
CD player section
System
Compact disc and digital
audio system
audio system
Laser
Semiconductor laser
(
(
λ
=780nm)
Emission duration:
continuous
continuous
Laser output
Max. 44.6
µ
W*
*This output is the value
measured at a distance of
200 mm from the
objective lens surface on
the Optical Pick-up Block
with 7 mm aperture.
measured at a distance of
200 mm from the
objective lens surface on
the Optical Pick-up Block
with 7 mm aperture.
Frequency response
2 Hz – 20 kHz (±0.5 dB)
Wavelength
780 – 790 nm
Signal-to-noise ratio
More than 90 dB
Dynamic range
More than 90 dB
CD OPTICAL DIGITAL OUT
(Square optical connector jack, rear panel)
Wavelength
(Square optical connector jack, rear panel)
Wavelength
600 nm
Output Level
–18 dBm