Sony dru-820a User Manual

9

In

tr

oduc

ti

on

A Disc tray

Insert discs here, label side up.

When you insert a disc into the drive, make 
sure that it is under the four pins. When using 
the drive vertically, make sure that you set the 
disc inside the two lower pins.

B Eject button

Press to open and close the disc tray.

C Busy indicator

Indicates the drive status.
Lit : 

The drive is reading data, 
playing back an audio CD, or 
writing packets.

Blinking:  The drive is writing data 

(disc-at-once, track-at-once), 
formatting a disc, or 
deleting

1)

 data from a disc.

Off : 

The drive is in a state other 
than those outlined above.

1)

Some drives indicate this state with the lit 
indicator.

D Emergency eject hole

If you cannot open the disc tray with the 
eject button, turn off your computer, and 
then insert a thin, elongated object into 
this hole to eject the disc tray manually.

E Do not use.

F Analog audio connector

Analog stereo audio output. Using an 
audio cable, connect to the audio 
connector of a computer with a sound 
card.

Connecting a cable other than an audio 
cable or otherwise misusing the audio 
connector may cause damage to the 
product.

G Jumper

A jumper is set on the appropriate pins 
before connecting the drive.

H IDE connector

Connect to the computer with the IDE 
flat cable.

I Pin 1

The location of this pin determines the 
proper orientation of the connection 
cable.

J Power connector

Connect the connector of the computer’s 
internal power supply.

About 40 mm (1.6 in)

CSEL

SLAVE

MASTER

CSEL

SLAVE

MASTER

Jumper pins

Jumper pins

5V GND 12V

DC INPUT