Sony DSR-250 User Manual
7
Getting started
Step 1 Installing the microphone
Install the supplied microphone. Be sure to connect the microphone plug to the MIC IN
+48V connector.
+48V connector.
(1) Attach the wind screen to the microphone.
(2) Loosen the microphone holder screw and open the cover.
(3) Place the microphone into the holder with the model name (ECM-NV1) facing
(2) Loosen the microphone holder screw and open the cover.
(3) Place the microphone into the holder with the model name (ECM-NV1) facing
upward, close the cover, and tighten the screw.
(4) Connect the plug of the microphone to the MIC IN +48V connector.
(5) Set the AUDIO INPUT switches to FRONT, and the AUDIO SELECT switches
(5) Set the AUDIO INPUT switches to FRONT, and the AUDIO SELECT switches
to AUTO, for both channels 1 and 2.
When you manually adjust the audio level, see “Adjusting the recording level
manually – Sound recording level” on page 54.
When you manually adjust the audio level, see “Adjusting the recording level
manually – Sound recording level” on page 54.
When the wind is blowing hard
When inputting the sound via the MIC IN +48V connector, you can reduce the wind noise.
Set the MIC LOW CUT switch to ON. This is only activated for the front microphone.
When inputting the sound via the MIC IN +48V connector, you can reduce the wind noise.
Set the MIC LOW CUT switch to ON. This is only activated for the front microphone.
When you unplug the microphone plug
Unplug it while pressing the PUSH button.
Unplug it while pressing the PUSH button.
1
2
3
4
5
AUDIO
INPUT
AUDIO
SELECT
CH-1
CH-2
FRONT
REAR
AUTO
MANUAL
FRONT
REAR
AUTO
MANUAL
MIC LOW CUT switch