Sony DRC-BT30 User Manual

Page of 56
DRC-BT30 [US, ES]_4-156-247-51(1)
US
WARNING
To reduce the risk of electrical shock, do 
not open the cabinet. Refer servicing to 
qualified personnel only.
Do not install the appliance in a confined 
space, such as a bookcase or built-in cabinet.
Do not expose the batteries (battery pack or 
batteries installed) to excessive heat such as 
sunshine, fire or the like for a long time.
Excessive sound pressure from headphones 
can cause hearing loss.
Information
If you have any questions about this product, 
you may call:
Sony Customer Information Service Center 
1-800-222-7669 or http://www.sony.com/
Declaration of Conformity
Trade Name: 
SONY
Model No.: 
DRC-BT30
Responsible Party:  Sony Electronics Inc.
Address: 
16530 Via Esprillo, 
San Diego, CA 92127 
USA
Telephone No.: 
858-942-2230
This device complies with Part 15 of the 
FCC Rules. Operation is subject to the 
following two conditions: (1) this device 
may not cause harmful interference, and 
(2) this device must accept any 
interference received, including 
interference that may cause undesired 
operation.
This device complies with Part 15 of FCC 
Rules and RSS-Gen of IC Rules. Operation is 
subject to the following two conditions: (1) 
this device may not cause harmful 
interference, and (2) this device must accept 
any interference received, including 
interference that may cause undesired 
operation of this device.
You are cautioned that any changes or 
modifications not expressly approved in this 
manual could void your authority to operate 
this equipment.
This equipment must not be co-located or 
operated in conjunction with any other 
antenna or transmitter.
This equipment complies with FCC/IC 
radiation exposure limits set forth for 
uncontrolled equipment and meets the FCC 
radio frequency (RF) Exposure Guidelines in 
Supplement C to OET65 and RSS-102 of the 
IC radio frequency (RF) Exposure rules. This 
equipment has very low levels of RF energy 
that it is deemed to comply without testing 
of specific absorption ratio (SAR).
Note
This equipment has been tested and found to 
comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide 
reasonable protection against harmful 
interference in a residential installation. This 
equipment generates, uses and can radiate 
radio frequency energy and, if not installed 
and used in accordance with the 
instructions, may cause harmful interference 
to radio communications. However, there is 
no guarantee that interference will not occur 
in a particular installation. If this equipment 
does cause harmful interference to radio or 
television reception, which can be 
determined by turning the equipment off 
and on, the user is encouraged to try to 
correct the interference by one or more of 
the following measures:
–  Reorient or relocate the receiving antenna.
–  Increase the separation between the 
equipment and receiver.
–  Connect the equipment into an outlet on 
a circuit different from that to which the 
receiver is connected.
–  Consult the dealer or an experienced 
radio/TV technician for help.
The Bluetooth word mark and logos are 
owned by the Bluetooth SIG, Inc. and any 
use of such marks by Sony Corporation is 
under license.