Sony DR-EX300iP User Manual

Stereo 

Headset

DR-EX300iP

©2010   Sony Corporation     Printed in Thailand

4-180-388-12(1)

Operating Instructions
Manual de instrucciones







Colored parts

Sectional View







You are cautioned that any changes or 

modifications not expressly approved 

in this manual could void your 

authority to operate this equipment.

You can use the unit with only the 

following models supporting remote 

control. Update your iPod, iPhone or 

iPad to the latest software before use. 

In the Operating Instructions, iPod, 

iPhone and iPad are collectively 

described as “iPod” except in special 

cases.

  iPod touch 4th generation

  iPod touch 3rd generation

  iPod touch 2nd generation

  iPod nano 6th generation

  iPod nano 5th generation

  iPod nano 4th generation

  iPod classic 120GB 160GB (2009)

  iPod shuffle 4th generation

  iPod shuffle 3rd generation

  iPhone 4

  iPhone 3GS

  iPad

iPhone

®

, iPod

®

, iPod classic

®

, iPod 

nano

®

, iPod shuffle

®

, and iPod 

touch

®

 are trademarks of Apple Inc., 

registered in the U.S. and other 

countries. iPad

®

 is a trademark of 

Apple Inc.

“Made for iPod,” “Made for iPhone,” 

and “Made for iPad” mean that an 

electronic accessory has been designed 

to connect specifically to iPod, iPhone, 

or iPad, respectively, and has been 

certified by the developer to meet 

Apple performance standards. Apple is 

not responsible for the operation of 

this device or its compliance with 

safety and regulatory standards.

  Easy-to-use remote control (only for 

iPod, iPhone and iPad).

  In-line microphone for hands-free 

phone calls of iPhone.

  Closed type vertical in-the-ear 

headphones for wearing comfort.

  13.5mm driver units reproduce 

vocal and instrumental sound with 

vivid clarity.

  Hybrid silicone rubber earbuds for 

secure fit and long-term wearing 

comfort.

(see fig. )

Wear the earpiece marked  in your 

right ear and the one marked  in 

your left ear.

(see fig. -)

Move up and down to change the split 

position of the cord.

(see fig. -)

You can adjust the cord length by 

winding the cord on the cord adjuster.

(The cord can be wound to the cord 

adjuster up to 50 cm (19 

3

/

4

 in). If you 

wind more, the cord comes off from 

the cord adjuster easily.)

Do not wind the plug or split section of the 

cord, as it will strain the cord and may cause 

a wire break.

iPod (see fig. -) 

You can control a connected iPod 

product.

 Volume +

Increases the volume of the connected 

iPod product. 

 Center button

Plays/pauses a track of the connected 

iPod product with a single press. Skips 

to the next track with a double press. 

Skips to the previous track with a triple 

press. Starts the “VoiceOver*” feature 

with a long press (if available).

Press once to answer the call. Press 

again to end.

Hold down for about two seconds to 

reject an incoming call.

When you let go, two low beeps 

confirm the call was rejected.

 Volume –

Decreases the volume of the connected 

iPod product.

 Microphone

* Availability of the “VoiceOver” feature 

depends on iPod and its software version.

correctly (see fig. )

If the earbuds do not fit your ears 

correctly, low-bass sound may not be 

heard. To enjoy better sound quality, 

change the earbuds to another size, or 

adjust the earbuds position to sit on 

your ears comfortably and fit your ears 

snugly.

If the earbuds do not fit your ears, try 

another size. Confirm the size of the 

earbuds by checking color inside  

(see fig. -). 

When you change the earbuds, turn to 

install them firmly on the headphones 

to prevent the earbud from detaching 

and remaining in your ear.

Small 



Large 



SS

* 

(Red)

S 

(Orange)

M 

(Green)

L 

(Light blue)

* This size is optional and available at 

purchase.

(see fig. -)

While holding the headphone, twist 

and pull the earbud off.

 Tip

If the earbud slips and cannot be detached, 

wrap it in a dry soft cloth.

(see fig. -)

Push the parts inside of the earbud into 

the headphone until the projecting 

part of the headphone is fully covered. 

Remove the earbuds from the 

headphones, and wash them with a 

mild detergent solution. 

Closed, dynamic

 

13.5 mm, dome type 

(CCAW)

100 mW (IEC*)

 

16 Ω at 1 kHz

 

105 dB/mW

Frequency response:   

5 – 24,000 Hz

1.2 m (47 

1

/

4

 in), Litz cord  

Y-type

Four-conductor gold-plated 

stereo mini plug for iPod 

with remote function

Approx. 6 g (0.21 oz) 

without cord

 

– 42 dB ( 0 dB=1 V/Pa)

Earbuds (S × 2, M × 2, L × 2)

Cord adjuster (1)

Carrying case (1)

Card warranty (1)

Operating Instructions (1)

* IEC = International Electrotechnical 

Commission 

Design and specifications are subject 

to change without notice.

  Please keep your headphones clean 

at all times especially inside the 

rubber earbud. (see fig. ) 

If any dust or ear wax inside the 

earbud, you may experience some 

listening difficulties.

  Listening with headphones at high 

volume may affect your hearing. For 

traffic safety, do not use while 

driving or cycling.

  The earbuds may deteriorate due to 

long-term storage or use.

  Install the earbuds firmly onto the 

headphones. If an earbud 

accidentally detaches and is left in 

your ear, it may cause injury.

  Be careful not to allow any buttons 

to be unintentionally pressed when 

the headphones with iPod connected 

are in the supplied carrying pouch, 

etc.

In particularly dry air conditions, mild 

tingling may be felt on your ears. This 

is a result of static electricity 

accumulated in the body, and not a 

malfunction of the headphones.  

The effect can be minimized by 

wearing clothes made from natural 

materials.

EP-EX10A is available (sold 

separately) as optional replacement 

earbuds.

EP-EX10A offers 4 types of the 

earbuds: SS, S, M and L.






