Sony 500WSPL User Manual

Chapter 2  Fitting and Connections

Chapter 2  Fitting and Connections

45

• The camcorder does not support the noiseless

function of the various speed playback.

• The slow playback will be automatically released to

protect the tape if the slow playback lasts for about
one minute.

You can do cut editing and digital dubbing when connecting the DSR-70/70P with fitting the optional DSBK-140,
using an i.LINK cable (DV connecting cable).

BVW-50/50P/35/
35P (portable)

CCZ-A Camera
cable (max. length
10 m (33 ft.))

VO-8800/6800
(U-matic)

CCZQ-A Camera
cable (max. length
10 m (33 ft.))

VTR connector

VTR connector

DV OUT
connector

Digital
Videocassette
Recorder DSR-
20/20P/70/70P/
2000/2000P, etc.

i.LINK cable (DV
connecting cable)
(max. length
4.5 m (14 ft.))

DSR-500WSL/500WSPL

DV OUT

i.LINK cable (DV connecting cable)

DV IN

DSR-70/70P Digital
Videocassette Recorder

• There is no power supply connection between the

camcorder and VCR. Provide separate power
supplies.

• The VTR connector always outputs the signals from

the camera (impossible to output the playback video
of the internal VCR), and disallows the CCU
connection.

• When no VCR is connected to the VTR connector

(26-pin), it does not supply signals.

You can use a following external VCR connected to
the VTR connector (26-pin) or the DV OUT connector
for recording.

• When dubbing tapes using the DSR-70/70P, a

continuous recorded section of approximately five
seconds is required before the recording start point. It
is recommended to record beforehand color bars or a
similar signal at the start point of the source tape to
be dubbed on this unit.