Sony dvo-1000md User Manual

O

v

er

v

iew

Connection

14

This section gives an example to connect external 
equipment for controlling the unit from connected 
external equipment 

Settings required for using this connection 
example 
Make the following settings before operating in this 
connection example using SETUP MENU.
For detailed information on menu operation, see “Basic 
Menu Operations” on page 50.
• Audio output selection

Select the audio output channel using the AUDIO 
MON CH sub menu of SETUP MENU (see page 47).
– LCH: Outputs the audio signal of audio channel 1.

– RCH: Outputs the audio signal of audio channel 2.
– MIX: Outputs a mixed audio signal from both 

channel 1 and channel 2. (factory setting)

Select the input signal “ANALOG” using the INPUT 
SELECT sub menu of SETUP MENU (see page 24).

Select an interface to control the unit from among 
RS232C (factory setting), USB and iLINK (see 
page 20). 
When controlling the unit, only one interface is 
available from among RS232C (factory setting), USB 
and iLINK.

S-video cable (not supplied)

RS-232C cable (cross type/not supplied)

1

2

3

4

Audio cable (not supplied)

Audio cable (not supplied)

DV cable (not supplied)

5

6

7

AC power cable (not supplied)

USB cable (not supplied)

S-VIDEO IN

S-VIDEO OUT

To analog audio input connector

To S-video input connector

Video monitor

MONITOR AUDIO

To S-video 
output connector

AUDIO IN L/R

REMOTE IN RS-232C 

USB 

DV IN (i.LINK) 

to RS-232C connector

to DV connector

to USB connector

To analog audio 
output connector

- AC IN

to AC outlet

External equipment

1

2

1

4

5

6

7

You can use only one interface from among RS-232C, USB and 
iLINK interfaces to control the unit remotely.

3