Sony DVP-F35P User Manual
27
H
ook
up
s
s
12
Press X/x to select whether or
not you wish to send a DTS signal
to your amplifier (receiver).
to your amplifier (receiver).
through
).
• OFF (page 72)
• ON (only if the amplifier (receiver) has
a DTS decoder) (page 72)
13
Press ENTER.
Quick Setup is finished. All connections
and setup operations are complete.
If your AV amplifier (receiver) has an
MPEG audio decoder, set “MPEG” to
“MPEG” (page 72).
and setup operations are complete.
If your AV amplifier (receiver) has an
MPEG audio decoder, set “MPEG” to
“MPEG” (page 72).
Enjoying the surround sound
effects
effects
To enjoy the surround sound effects of this
player or your amplifier (receiver), set the
following items as described below for the
audio connection you selected on pages 22 to
24 (
player or your amplifier (receiver), set the
following items as described below for the
audio connection you selected on pages 22 to
24 (
through
). Each of these is the
default setting and does not need to be
adjusted when you first connect the player.
See page 66 for using the Setup Display.
adjusted when you first connect the player.
See page 66 for using the Setup Display.
• No additional settings are needed.
• Set “DOWNMIX” to “DOLBY
SURROUND” (page 71)
• If the sound distorts even when the volume
is turned down, set “AUDIO ATT” to “ON”
(page 71)
(page 71)
• Set “DOWNMIX” to “DOLBY
SURROUND” (page 71)
• Set “DIGITAL OUT” to “ON” (page 71)
Attaching the Stand
You can use the player laid horizontally, or in
an vertical position. Be sure to attach the
supplied stand when using in the vertical
position.
an vertical position. Be sure to attach the
supplied stand when using in the vertical
position.
1
Fit the projection of the stand into
the
slot on the
side of the player.
2
Slide the stand back and forth to
align the screw holes.
align the screw holes.
Select two screw holes to decide the foot
position.
position.
3
Secure the two supplied screws.
4
Stand the player up.
B
D
B-2
C-2
D
B
D
A
B-1
C-1
B-2
C-2
D
,
continued