Sony dvp-nc650v User Manual

Page of 104
3
Precautions
On safety
• Caution – The use of optical instruments 
with this product will increase eye hazard.
• Should any solid object or liquid fall into 
the cabinet, unplug the player and have it 
checked by qualified personnel before 
operating it any further.
On power sources
• The player is not disconnected from the AC 
power source as long as it is connected to 
the wall outlet, even if the player itself has 
been turned off.
• If you are not going to use the player for a 
long time, be sure to disconnect the player 
from the wall outlet. To disconnect the AC 
power cord, grasp the plug itself; never pull 
the cord.
• Should the AC power cord need to be 
changed, have it done at a qualified service 
shop only.
On placement
• Place the player in a location with adequate 
ventilation to prevent heat build-up in the 
player.
• Do not place the player on a soft surface 
such as a rug.
• Do not place the player in a location near 
heat sources, or in a place subject to direct 
sunlight, excessive dust, or mechanical 
shock.
On operation
• If the player is brought directly from a cold 
to a warm location, or is placed in a very 
damp room, moisture may condense on the 
lenses inside the player. Should this occur, 
the player may not operate properly. In this 
case, remove the disc and leave the player 
turned on for about half an hour until the 
moisture evaporates.
• When you move the player, take out any 
discs. If you don’t, the disc may be 
damaged.
On adjusting volume
Do not turn up the volume while listening to 
a section with very low level inputs or no 
audio signals. If you do, the speakers may be 
damaged when a peak level section is played.
On cleaning
Clean the cabinet, panel, and controls with a 
soft cloth slightly moistened with a mild 
detergent solution. Do not use any type of 
abrasive pad, scouring powder or solvent 
such as alcohol or benzine.
If you have any questions or problems 
concerning your player, please consult your 
nearest Sony dealer.
On cleaning discs
Do not use a commercially available cleaning 
disc. It may cause a malfunction.
On transporting the player
Before transporting the player, follow the 
procedure below to return the internal 
mechanisms to their original positions.
1
Remove all the discs from the disc tray.
2
Press A to close the disc tray.
Make sure that “NO DISC’ appears on 
the front panel display.
3
Wait for 10 seconds, then press ?/1 on 
the remote, followed by POWER on the 
player.
This will safely turn off the player.
IMPORTANT NOTICE
Caution: This player is capable of holding a 
still video image or on-screen display 
image on your television screen 
indefinitely. If you leave the still video 
image or on-screen display image displayed 
on your TV for an extended period of time 
you risk permanent damage to your 
television screen. Projection televisions are 
especially susceptible to this.