Sony DVS-9000-C User Manual
1-17
DVS-9000/9000SF
1-8. Checks on Completion of Installation
DI3 (F-3), DI6 (F-3), DI7 (F-3), DI8 (F-4) (green) :
STATUS1 to STATUS4 LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
STATUS1 to STATUS4 LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
DI4 (green) (B-5) :
+
+
+
+
+3.3 V
Indicates the status of the VCC (CORE) and VCC (I/O)
powers that are supplied to the CPU-DK module.
powers that are supplied to the CPU-DK module.
<Switch on the CPU DK module> : COM CPU-1
: COM CPU-2
SW1 (D-5) : RESET switch
Pressing this switch resets the CPU-DK module.
n
In some machines in which the CPU-DK module is
installed, the system reset may be activated.
Pressing this switch resets the CPU-DK module.
n
In some machines in which the CPU-DK module is
installed, the system reset may be activated.
SW2 (C-5) : MODE switch
8-pin DIP switch
Used only for production in the assembly factory. All
switches are set to OFF for normal operation.
Default setting when shipped from the factory is all OFF.
8-pin DIP switch
Used only for production in the assembly factory. All
switches are set to OFF for normal operation.
Default setting when shipped from the factory is all OFF.
<LED on the IF-844 board> : S-BUS
D1 (B-1) : SBUS RX status LED
Lit when receiving data.
D1 (B-1) : SBUS RX status LED
Lit when receiving data.
<Switch on the IF-844 board> : S-BUS
S1 (B-3) : RESET switch
Pressing this switch resets the IF-844 board.
S1 (B-3) : RESET switch
Pressing this switch resets the IF-844 board.
<TEST terminal on the IF-844 board>
E1 (B-3) : GND terminal
Use this terminal as the earth point for measuring the
respective check terminals.
E1 (B-3) : GND terminal
Use this terminal as the earth point for measuring the
respective check terminals.
TP1 (A-2) : RX check terminal
S-BUS communication line measuring terminal.
S-BUS communication line measuring terminal.
TP2 (A-3) : TEST terminal
Terminal for testing.
Terminal for testing.