Sony FST-GTK2I User Manual

model name [FST-GTK2i]

[4-186-872-11(2)] GB

filename[D:\NORM'S JOB\SONY HA\SO0098\G-
Tank_PMRF\4186872112_GB\GB07ADD.fm]

masterpage:Left

If the unit still does not operate properly 
after performing the above measures or 
other troubles not described above occur, 
reset the unit as follows:
Use the buttons on the unit for the 
operation.

Press POWER on the back panel to 
turn off the AC power.

Press POWER again to turn on the 
AC power.

(Except North American model) 
Press ?/1 to turn on the unit.

Press and hold NX and GROOVE 
at the same time for about 5 
seconds.

“RESET” appears in the display.

The unit is reset to the factory settings.  
You need to readjust all the settings you 
made, such as the preset stations.

One of the following messages may 
appear or flash in the display during 
operation.

The radio preset operation ended 
normally.

The memory of the USB device could not 
be recognized

No USB device is connected.

No playable audio file is loaded in the 
unit.

Playable file on the USB device do not 
has artist information.

An unsupported USB device is connected, 
an unknown device is connected, or the 
USB device is connected through a USB 
hub (page 26).

An over current from the 

 (USB) port 

or iPod was detected.

The following causes can be considered:

• The ventilation holes may be blocked.
• The voltage selector may not be set to 

the correct local power line voltage.

See “If “PROTECT” appears on the 
display” (page 18) to check what to do if 
this message appears.

The unit is reading information of the 
USB device.