Sony HDS-X5800 User Manual

2-15 (E)

HDS-X5800

Upload the various setup data of the system equipment is executed from primary stations to a PC.

1.

Install the BZR-20 software. (Refer to Section 2-6-2.)

2.

Turn on the power of all the equipment on the S-BUS data link.

3.

Connect the PC to the REMOTE3 connector or the DATA (Ethernet) connector of the HDS-X5800
(or connect the PC to each equipment). (Refer to Section 2-6-1.)

4.

Turn on the power of the PC.

5.

Start up the BZR-20 software by clicking the BZR-20 icon. The following menu appears.

6.

Select a desired folder (any folder in the hard disk or FD drive) in which the uploaded setup data are
saved, from the File (F) menu of the menu bar. Press [OK].
n
You cannot create a new folder at this step.

7.

Select the desired button from “RECEIVE: PRIMARY to PC” column that suits to the contents of the
uploaded data and press the button.

[DescriptionF1] : It uploads the names of the total 2048 connectors of the SOURCE (input) and

DESTINATION (output) that are assigned to the primary station.

[CrosspointF2] : It uploads the latest cross-point data (1024 sources and 1024 destinations, level:

8) that are saved in the primary station.

[PrimaryF3] :

It uploads the setup data that are saved in the primary station.
(The data as the secondary station that are stored in the primary station are
uploaded at the same time.)
n
When uploading the setup data that are stored in the primary station, name of the
connecter and the cross-point data are not included.

[SecondaryF4] : It uploads the setup data of the equipment that is connected to the S-BUS remote.

Press  Cancel (C)  to stop uploading.

8.

When uploading is completed, press  Exit (E)  and close the BZR-20 window.

Set up the 
communication port.

Uploading the data 
(Section 2-6-3)

Select a folder in which the uploaded or 
downloaded setup data are saved.

Simplified description of operation manual

Downloading the data 
(Section 2-6-4)

2-6. Data Backup