Sony hcd-101 User Manual
27
4
Press CHARACTER on the remote
repeatedly until the desired type of
character appears.
repeatedly until the desired type of
character appears.
Each time you press the button, the
display changes as follows:
display changes as follows:
A (Upper cases) n a (Lower cases) n 0
(Numbers)/! (Symbols)* n
(Numbers)/! (Symbols)* n
(Space)
n
A…
*You can use the following symbols.
5
Press + or – on the remote until the
desired character appears.
desired character appears.
The selected character flashes. To enter a
blank space, press / on the remote
while the cursor is flashing.
blank space, press / on the remote
while the cursor is flashing.
6
Press / on the remote.
The character you selected in step 5
lights up and the cursor shifts to the
right.
lights up and the cursor shifts to the
right.
7
Repeat steps 4 through 6 to
complete the entire title.
complete the entire title.
If you make a mistake, press ? or / on
the remote until the character you want
to change flashes, then repeat steps 4
through 6.
To erase the character, press EDIT/NO
while the character is flashing.
the remote until the character you want
to change flashes, then repeat steps 4
through 6.
To erase the character, press EDIT/NO
while the character is flashing.
If you try to labell more than 10
character, “Name Full” is displayed.
character, “Name Full” is displayed.
8
Press YES to complete the labelling
procedure.
procedure.
The disc name is displayed.
To cancel labelling
Press p.
To erase a disc name
1 Press EDIT/NO repeatedly until “Name
Erase ?” appears.
2 Press YES.
The disc name appears.
“No Name” appears if no disc name is
stored.
“No Name” appears if no disc name is
stored.
3 Press YES again.
“Complete” appears and the disc name is
erased.
erased.
Note
You can not labell during playing a CD.
! " # $ % & ' ( )
∗
+ , – . / : ; < = > ? @
_ `