Sony HT-SS2000 User Manual

GB

D:\CANNES\SONY_HA\JOB 2007\HT-SS2000\IM_SS2000\Data_CEL\Data_GB\GB06OTH_HT-
SF2000-CEL.fm

[HT-SF2000/HT-SS2000]

3-210-806-11

(1)

 

 

 

 

 

 

 

If there is a malfunction, the display shows a 
message. You can check the condition of the 
system by the message. Refer to the following 
table to solve the problem. If any problem 
persists, consult your nearest Sony dealer.
If an error message appears while you perform 
Auto Calibration, see “When error codes 
appear” (page 28) to solve the problem.

Irregular current is output from the 
speakers. The receiver will automatically 
turn off after a few seconds. Check the 
speaker connection and turn on the power 
again.

Clearing the receiver’s memory may remedy 
the problem (page 24). However, note that all 
memorized settings will be reset to their 
factory settings and you will have to readjust 
all settings on the receiver.

Consult your nearest Sony dealer. Note that if 
service personnel changes some parts during 
repair, these parts may be retained.

 

(Models of area code U, UC only)
With 3 ohm loads, both channels driven, from 
170 – 20,000 Hz; rated 84 watts per channel 
minimum RMS power, with no more than 1% 
total harmonic distortion from 250 milliwatts 
to rated output.

Models of area code U, UC
Power Output

1)

Stereo mode (rated) 84 W + 84 W 

(3 ohms at 170-20,000 Hz,  
THD 1%)

Surround mode (reference)

RMS Output 
(3 ohms at 1 kHz,  
THD 10%) 
FRONT

2)

: 143 W/ch

CENTER

2)

: 143 W

SUR

2)

: 143 W/ch 

(1.5 ohms at 80 Hz,  
THD 10%)
SUBWOOFER

2)

: 285 W

Models of area code CEL, CEK
Power Output

1)

Stereo mode (rated) 108 W + 108 W  

(3 ohms at 1 kHz,  
THD 1%)

Surround mode (reference) 

RMS Output 
(3 ohms at 1 kHz,  
THD 10%)  
FRONT

2)

: 143 W/ch

CENTER

2)

: 143 W

SUR

2)

: 143 W/ch 

(1.5 ohms at 80 Hz,  
THD 10%)
SUBWOOFER

2)

: 285 W

All memorized settings

Customized sound fields