Sony HTSS380 User Manual

 

 

 

 

 

 

 

If there is a malfunction, a message appears on 
the display panel. You can check the condition 
of the system by the message. If any problem 
persists, consult your nearest Sony dealer.
If an error message appears while you perform 
Auto Calibration, see “When error codes 
appear” (page 27) to solve the problem.

Irregular current is output to the speakers, 
the volume level is too high, or the upper 
panel of the receiver is covered and 
ventilation holes are blocked. The receiver 
will automatically turn off after a few 
seconds. Check the speaker connection and 
remove the object covering the ventilation 
holes. 
Turn on the power and increase the volume 
level.

If you are unable to remedy the problem using 
the troubleshooting guide, clearing the 
receiver’s memory may remedy the problem. 
However, note that all memorized settings will 
be reset to the default settings and you will 
have to readjust all settings on the receiver.

POWER OUTPUT AND TOTAL 
HARMONIC DISTORTION:
(FTC)
(USA model only)
FRONT L + FRONT R

With 3 ohm loads, both 
channels driven, from 180 
– 20,000 Hz; rated 84 watts 
per channel minimum 
RMS power, with no more 
than 1% total harmonic 
distortion from 250 
milliwatts to rated output.

POWER OUTPUT (reference)
FRONT L/FRONT R/CENTER/SUR L/SUR R

167 W (per channel at 

 

3 ohms, 1 kHz)

SUBWOOFER

165 W (at 3 ohms, 60 Hz)

Inputs 

Analog

Sensitivity: 1 V/50 kohms

Digital (Coaxial) Impedance: 75 ohms

Tuning range

87.5 MHz – 108.0 MHz 
(100 kHz step)

Antenna

FM wire antenna (aerial)

Antenna terminals

75 ohms, unbalanced

Power requirements 120 V AC, 60 Hz
Power output (DMPORT)

DC OUT:

5 V, 1 A MAX

Power consumption 110 W
Power consumption (during standby mode)

0.3 W (When Control for 
HDMI is set to off)

All memorized settings