Sony ipela nsr series User Manual

101

Chapter 5  Settings

If these settings are modified, the camera settings of the NSR also need to 
be modified. 

Once you have configured all the desired settings, click [Connect]. 

The settings are used to connect to the camera and the camera is registered 
once it is detected. 

If the specified IP address is the same as that of an already registered 
camera, a warning appears and the camera cannot be registered. 

Click [Camera] in the tree on the left side of the window.

The Camera screen appears.

Select the camera to delete, and click [Delete] at the top right of the screen.

To delete multiple cameras, select the cameras while holding down the Shift 
key or Ctrl key.

The delete confirmation screen appears.

Click [OK].

The camera is deleted.

When a camera is deleted, “No Camera” appears in the monitor window of the 
layout. With the default layout, the next camera that you register will be 
assigned to the open monitor window.
When a registered camera is deleted, data recorded during the registered period 
cannot be searched. In such a case, recorded data is not deleted. Recorded data 
can be deleted when the conditions for deletion from storage or data overwrite 
are met. For details on settings, see “Storage” under “General” of “Advanced 
Configuration” (page 84).

You can configure advanced settings such as the main, preset, mask, and motion 
detection settings for each camera individually.