Sony kds-60a3000 User Manual

Page of 51
5
Electric shock
Do not touch the AC power cord or the TV with a wet 
hand. If you plug/unplug the AC power cord from the TV 
with a wet hand, it may cause electric shock.
Cleaning
s Clean the rear cover area of the TV regularly. Dust in the rear cover 
area may cause a problem with the cooling system of the TV set.
s Clean the cabinet of the TV with a dry soft cloth. 
To remove dust from the screen, wipe it gently 
with a soft cloth. Stubborn stains may be 
removed with a cloth slightly dampened with 
solution of mild soap and warm water. Never use 
strong solvents such as thinner or benzine for cleaning. If the picture 
becomes dark after using the TV for a long period of time, it may be 
necessary to clean the inside of the TV. Consult qualified service 
personnel.
s Unplug the AC power cord when cleaning this unit. 
Cleaning this unit with a plugged AC power cord 
may result in electric shock.
On Contamination on the Screen Surface 
The screen surface has a special coating to reduce reflections. To prevent 
screen damage, clean the screen as follows:
s Clean the screen with a soft cloth. 
s To remove hard contamination, use a cloth moistened with a solution 
of mild detergent and water. Do not spray cleaning solution directly 
onto the TV. It should only be sprayed to moisten the cleaning cloth.
s Do not use any type of abrasive pad, alkaline cleaner, acid cleaner, 
scouring powder, chemical cloth, or solvent such as alcohol, benzene 
or thinner, as these may scratch the screen’s coating. 
Service
Damage Requiring Service
Do not attempt to service the set by yourself since 
opening the cabinet may expose you to dangerous 
voltage or other hazards. 
Unplug the set from the wall outlet and refer servicing to 
qualified service personnel.
Replacement Parts
When replacement parts are required, be sure the service technician 
certifies in writing that he has used replacement parts specified by the 
manufacturer that have the same characteristics as the original parts.
Unauthorized substitutions may result in fire, electric shock or other 
hazards.
For Safety
Be Careful When Moving the 
TV
When you place the TV in position, be careful 
not to drop it on your foot or fingers.
Watch your footing while installing the TV.
Carry the TV in the Specified 
Manner
If you carry the TV in a manner other than the specified manner and 
without the specified number of persons, it may drop and a serious injury 
may be caused. Be sure to follow the instructions mentioned below.
s Carry the TV with the specified number of persons (see page 8).
s Hold the TV tightly when carrying it.
s Before carrying the TV, disconnect any accessories or cables.
For Safe Operations
Always switch off by pressing POWER button on the remote or the TV 
first to ensure proper lamp cooling process.
Caution
Do not use the TV at altitudes higher than 3,000 m, as doing so might 
cause malfunction.
About the TV
Although the TV is made with high-precision technology, black dots may 
appear or bright points of light (red, blue, or green) may appear constantly 
on the screen. This is a structural property of the panel and is not a defect.
Installation
s If direct sunlight or other strong illumination shines on the screen, 
part of the screen may appear white due to reflections from behind the 
screen. This is a structural property of the TV.
Do not expose the screen to direct illumination or direct sunlight.
s The picture quality may be affected by your viewing position. For the 
best picture quality, install your TV according to “Recommended 
Viewing Area” on page 9.
s When installing your TV against a wall, keep it at least 4 inches (10 
cm) away from the wall.
Projection Lamp
s Your TV uses a projection lamp as its light source. It is time to replace 
the lamp with a new one (not supplied) when:
• the message, “Projection lamp is nearing end of life. Please 
replace the lamp.” appears on the screen,
• the lamp replacement indicator on the front panel blinks in red,
• screen images become dark,
• no image appears on the display after prolonged use.
s In rare instances, the bulb may pop inside the lamp unit, but the lamp 
unit is designed to contain all of broken glass pieces inside the lamp 
unit. (See “Replacing the Lamp” on page 44.)
s When the lamp eventually burns out, you may hear a noticeable pop 
sound. This is normal and is inherent in this type of lamp.
Cooling Fans
This TV uses cooling fans. You may hear the noise of fans running, 
depending on the placement of your TV. The noise may be more 
noticeable during the night or when the background noise level is low.
Disposal of Used Batteries
To preserve our environment, dispose of used batteries according to your 
local laws or regulations.
For Customers in the United States
Lamp in this product contains mercury. Disposal of 
these materials may be regulated due to 
environmental considerations. For disposal or 
recycling information, please contact your local 
authorities or the Electronic Industries Alliance 
(http://www.eiae.org).
POWER
STD/DUO
KDS-50A3000
KDS-55A3000/
KDS-60A3000
5