Sony klv-27hr3 User Manual

This TV set is designed to operate 

on a 220-240V AC supply only. 

Take care not to connect too 

many appliances to the same 

mains socket as this could result 

in fire or electric shock.

Pull out the mains lead by the 

plug. Do not pull on the mains 

lead itself.

Unplug the mains lead when wiring cables. Be sure to 

unplug the mains lead for your safety, when hooking up.

Clean the mains plug regularly. If the 

plug is covered with dust and it picks up 

moisture, its insulation may deteriorate 

and result in fire. Unplug the mains plug 

and clean it regularly.

For environmental and safety 

reasons, it is recommended that 

the TV set is switched off when 

not in use - not left in standby 

mode. Disconnect from the 

mains.

Do not use a poor fitting mains socket. Insert 

the plug fully into the mains. If it is loose, it 

may cause arcing and result in fire. Contact 

your electrician to have the mains socket 

changed.

Do not touch the mains lead with a wet 

hand. If you plug/unplug the mains lead 

with a wet hand, it may cause electric 

shock.

For your own safety, do not touch 

any part of the TV set, mains lead 

or aerial lead during lightning 

storms.

If you damage the mains lead, it 

may result in fire or electric 

shock. 

• Do not pinch, bend, or twist the 

cable excessively. The core 

lines may be bared or cut, 

causing a short - circuit which 

may in fire or electric shock. 

• Do not convert or damage the 

mains lead. 

• Do not put anything heavy on the mains lead. Do not 

pull the mains lead. 

• Keep the mains lead away from heat sources. 

• Be sure to grasp the plug when disconnecting the 

mains lead. 

•  If the mains lead is damaged, stop using it and ask your 

dealer or Sony service centre to exchange it.

•  Do not use supplied mains lead on any other 

equipment.

•  Use only original Sony mains lead, not other brands.

Do not touch the TV set with wet hands. Doing so may 

cause electric shock or damage the TV set.

If you use this set near the seashore, salt may corrode 

metal parts of the TV set and cause internal damage or 

fire. It may also shorten the life of the TV set. Steps 

should be taken to reduce the humidity and temperature 

of the area where the set is located.

Take care not to catch your feet on the cables. It may 

damage the TV set. 

Do not install optional components too close to the TV 

set. Keep optional components at least 30 cm away from 

the TV set. If a VCR is installed in front or at the right 

side of the TV set, the picture may distort. 

Do not touch the surface of the TV. It remains hot, even 

after the TV has been turned off for some time.

Oils 

Do not install TV set in restaurants that use oil. Dust 

absorbing oil may enter into the TV set and damage TV 

set.

Water and moisture
Do not use the TV set near water – for example, near a 

bathtub or shower room. Also, do not expose to rain, 

moisture or smoke. This might result in fire or electric 

shock. Do not use the TV set where insects may enter.

Disposal of the TV set
• Do not dispose of the TV set with general household 

waste.

• The LCD contains a small amount of liquid crystal and 

mercury. The fluorescent tube used in the TV set also 

contains mercury. Follow your local ordinances and 

regulations for disposal

continued...