Sony MCE-C98K User Manual

29

• Caution — The use of optical instruments with this

product will increase eye hazard.

• Should any solid object or liquid fall into the cabinet,

unplug the player and have it checked by qualified
personnel before operating it any further.

• Before operating the player, check that the operating

voltage of the player is identical with your local power
supply. The operating voltage is indicated on the
nameplate at the rear of the player.

• The player is not disconnected from the AC power source

(mains) as long as it is connected to the wall outlet, even if
the player itself has been turned off.

• If you are not going to use the player for a long time, be

sure to disconnect the player from the wall outlet. To
disconnect the AC power cord (mains lead), grasp the
plug itself;  never pull the cord.

• AC power cord must be changed only at the qualified

service shop.

• Place the player in a location with adequate ventilation to

prevent heat build-up in the player.

• Do not place the player on a soft surface such as a rug that

might block the ventilation holes on the bottom.

• Do not place the player in a location near heat sources, or

in a place subject to direct sunlight, excessive dust or
mechanical shock.

If the player is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture may
condense on the lenses inside the player. Should this occur,
the player may not operate properly. In this case, remove the
disc and leave the player turned on for about an hour until
the moisture evaporates.

Do not turn up the volume while listening to a portion with
very low level inputs or no audio signals. If you do, the
speakers may be damaged when a peak level portion is
played.

Clean the cabinet, panel and controls with a soft cloth
slightly moistened with a mild detergent solution. Do not
use any type of abrasive pad, scouring powder or solvent
such as alcohol or benzine.

See page 7.

Do not pull or push the disc tray forcefully by hand.  It may
damage the player.

If you have any questions or problems concerning your
player, please consult your nearest Sony dealer.

Press the number buttons (1 - 10/0) to select the
scene.
To enter “0”, use the button 10/0.
Example:  To select scene number 103

Press 1, then 10/0 and 3.

The selected scene number appears on the TV
screen.

SCENE 103        (1 – 312)

Press CLEAR, then press the correct number button.

Press 

· to start playing from the selected scene.

The player automatically starts PBC Playback
(page 27).

z

Press ON SCREEN repeatedly to select ON SCREEN 2
display mode (see page 12). The scene numbers appear
on the upper left side of the TV screen.

• Some discs don’t allow you to start playing from a

particular scene. In this case, when you do the task before
you start playing, the player starts playing from scene 1.
When you do the task while playing a disc, the player
starts playing from the current scene.

• Some discs don’t display the selected scene on the TV

screen.

• When you select ON SCREEN OFF display mode, no

information is shown on the TV screen.