Sony md walkman mz-r55 User Manual

If the following error messages flash in the display window, check the chart below.

BLANK DISC

DISC ERR

DISC FULL

Data Save

Toc Edit

BUSY

NAME FULL

Hi DC in

HOLD

LOW BATT

MEM OVER

• An MD with no recording on it is inserted.

b Insert a recorded MD.

• The disc is damaged or does not contain proper recording or

editing data.
b Reinsert the disc. If this fails, rerecord.

• There is no more space to record on the disc (less than 12 seconds

available).
b Replace the disc.

• The MD player is recording information (sounds) from the memory

to the disk.
b Wait until this process is completed. Do not expose the player

to any physical shock, nor disrupt power supply.

• The MD player is recording information (track start and end

position) from the memory to the disk.
b Wait until this process is completed. Do not expose the player

to physical shock, nor disrupt power supply.

• You tried to operate the recorder while it was accessing the

recorded data.
b Wait until the message goes out (in rare cases, it may take 2–3

minutes).

• You tried to enter more than 200 letters to label a single track or

disc.

• You tried to enter a total of more than 1700 letters for track or disc

names during playback or stop.

• You tried to enter a total of more than 500 letters for track or disc

names during a single recording.
b Enter the characters within the limit.

• Voltage of the power supply is too high (The supplied AC power

adaptor or the recommended car battery cord is not used).
b Use the supplied AC power adaptor or the recommended car

battery cord.

• The recorder is locked.

b Slide HOLD against the arrow to unlock the recorder (page 20).

• Batteries are weak.

b Charge the rechargeable battery or replace the dry batteries

(pages 27, 28).

• You tried to record when there is no indication in the display, with

the recorder placed where it receives continuous vibration.
b Put the recorder on a stable place, and start recording again.