Sony MEX-BT2700 User Manual

D:\Documents and Settings\takashi-shimomura\Desktop\DTP\848626S MEX-
BT2700(U)\4125798111_MEX-BT2700(U)_CaFR\01US02CD-U.fm

MEX-BT2700

4-125-798-11 (1)

Output: Speaker outputs (sure seal connectors)
Speaker impedance: 4 – 8 ohms
Maximum power output: 52 W 

× 4 (at 4 ohms)

Outputs: 

Audio outputs terminal (front, sub/rear switchable)
Subwoofer output terminal (mono)
Power antenna (aerial) relay control terminal
Power amplifier control terminal

Inputs: 

Remote controller input terminal
Antenna (aerial) input terminal
Telephone ATT control terminal
BUS control input terminal
BUS audio input terminal
AUX input jack (stereo mini jack)

Tone controls: 

Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at 1 kHz (XPLOD)
High: ±10 dB at 10 kHz (XPLOD)

Power requirements: 12 V DC car battery 

(negative ground (earth))

Dimensions: Approx. 178 

× 50 × 179 mm 

(7

1

/

8

 

× 2 × 7

1

/

8

 in) (w/h/d)

Mounting dimensions: Approx. 182 

× 53 × 162 mm 

(7

1

/

4

 

× 2

1

/

8

 

× 6

1

/

2

 in) (w/h/d)

Mass: Approx. 1.2 kg (2 lb 11 oz)
Supplied accessories: 

Card remote commander: RM-X304
Parts for installation and connections (1 set)

Rotary commander: RM-X4S
BUS cable (supplied with an RCA pin cord): 
RC-61 (1 m), RC-62 (2 m)
CD changer (10 discs): CDX-757MX
CD changer (6 discs): CDX-T69
Source selector: XA-C40
AUX-IN selector: XA-300
Interface adaptor for iPod: XA-120IP
HD Radio

TM

 tuner: XT-100HD

Your dealer may not handle some of the above listed 
accessories. Please ask the dealer for detailed 
information.

The following checklist will help you remedy 
problems you may encounter with your unit.
Before going through the checklist below, check the 
connection and operating procedures.

If the problem is not solved, visit the following 
support site.

•  Halogenated flame retardants are not used in the 
  certain printed wiring boards.
•  Halogenated flame retardants are not used in 
 cabinets.
•  Packaging cushions are made from paper.

• Check the connection or fuse.
• If the unit is turned off and the display disappears, it 

cannot be operated with the remote commander. 

t Turn on the unit.

The power antenna (aerial) does not have a relay box.

• The ATT function is activated, or the Telephone ATT 

function (when the interface cable of a car telephone 
is connected to the ATT lead) is activated.

• The position of the fader control “FAD” is not set for 

a 2-speaker system.

• The Bluetooth audio device is in pause.

t Cancel pause.

• The beep sound is canceled (page 18).
• An optional power amplifier is connected and you are 

not using the built-in amplifier.

• The RESET button has been pressed.

t Store again into the memory.

• The power supply lead or battery has been 

disconnected or it is not connected properly.

The leads are not matched correctly with the car’s 
accessory power connector.

If no operation is performed for 5 minutes with 
“DEMO-ON” set, demonstration mode starts.
t Set “DEMO-OFF” (page 18).

t

http://esupport.sony.com
http://www.xplodsony.com/