Sony MDS-JE530 User Manual
51
GB
Additional Information
Menu item
Function
Parameters
Factory setting
Reference page(s)
Pitch
Changes the playback speed by auto steps.
–48 to +2
0
40
Pfine
Fine controls the playback speed.
–98.5 to +12.5%
0%
41
Ain
Adjusts the analog signal level input through
the LINE (ANALOG) IN jacks.
the LINE (ANALOG) IN jacks.
–
∞
to +12.0dB
0.0dB
17
Coax
–
∞
to +18.0dB
0.0dB
17
Opt
Adjusts the digital signal level input through
the DIGITAL OPTICAL IN connector.
the DIGITAL OPTICAL IN connector.
–
∞
to +18.0dB
0.0dB
17
Aout
Adjusts the analog signal level output to
the LINE (ANALOG) OUT and PHONES jacks.
the LINE (ANALOG) OUT and PHONES jacks.
–20.2 to 0.0dB
0.0dB
24
Sleep
Sets the duration of Sleep Timer.
30/60/90/120min
60min
42
Sleep
Turns Sleep Timer on or off.
On/Off
Off
42
To recall a factory setting
Press CLEAR while selecting the parameter.
Press CLEAR while selecting the parameter.
Self-Diagnosis Function
The deck’s self-diagnosis function automatically checks the condition of the MD deck when an error occurs, then issues a
three-digit code and an error message on the display. If the code and message alternate, find them in the following table
and perform the indicated countermeasure. Should the problem persist, consult your nearest Sony dealer.
three-digit code and an error message on the display. If the code and message alternate, find them in the following table
and perform the indicated countermeasure. Should the problem persist, consult your nearest Sony dealer.
Three-digit code/Message
Cause/Remedy
C11/Protected
The inserted MD is record-protected.
,
,
Take out the MD and close the record-protect slot (page 16).
C13/REC Error
The recording was not made properly.
,
,
Set the deck in a stable surface, and repeat the recording procedure.
The inserted MD is dirty (with smudges, fingerprints, etc.), scratched, or substandard in quality.
,
,
Replace the disc and repeat the recording procedure.
C13/Read Error
The deck could not read the TOC on the MD properly.
,
,
Take out the MD and insert it again.
C14/Toc Error
The deck could not read the TOC on the MD properly.
,
,
Insert another disc.
,
If possible, erase all the tracks on the MD (page 32).
C71/Din Unlock
The sporadic appearance of this message is caused by the digital signal being recorded. This will not affect
the recording.
the recording.
While recording from a digital component connected through the DIGITAL IN connector, the digital
connecting cable was unplugged or the digital component turned off.
,
connecting cable was unplugged or the digital component turned off.
,
Connect the cable or turn the digital component back on.
Adjusts the digital signal level input through
the DIGITAL COAXIAL IN jack.
the DIGITAL COAXIAL IN jack.