Sony mds-s707

2

This symbol is intended to
alert the user to the presence
of important operating and
maintenance (servicing)
instructions in the literature
accompanying the appliance.

This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules.  These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation.  This
equipment generates, uses, and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a
particular installation.  If this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to try
to correct the interference by one or
more of the following measures:

– Reorient or relocate the receiving

antenna.

– Increase the separation between the

equipment and receiver.

– Connect the equipment into an outlet

on a circuit different from that to
which the receiver is connected.

– Consult the dealer or an experienced

radio/TV technician for help.

You are cautioned that any changes or
modification not expressly approved in
this manual could void your authority
to operate this equipment.

The model and serial numbers are
located on the rear of the unit.
Record the serial number in the space
provided below.  Refer to them
whenever you call upon your Sony
dealer regarding this product.

Model No.  MDS-S707

Serial No.

The laser component in this product is
capable of emitting radiation exceeding
the limit for Class 1.

This appliance is classified as a CLASS 1
LASER product.  The CLASS 1 LASER
PRODUCT MARKING is located on the
rear exterior.

The following caution label is located
inside the unit.

This symbol is intended to
alert the user to the presence
of uninsulated “dangerous
voltage” within the product’s
enclosure that may be of
sufficient magnitude to
constitute a risk of electric
shock to persons.

TO PREVENT ELECTRIC SHOCK, DO
NOT USE THIS POLARIZED AC PLUG
WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET
UNLESS THE BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE
EXPOSURE.

IN NO EVENT SHALL SELLER BE
LIABLE FOR ANY DIRECT,
INCIDENTAL OR
CONSEQUENTIAL DAMAGES OF
ANY NATURE, OR LOSSES OR
EXPENSES RESULTING FROM
ANY DEFECTIVE PRODUCT OR
THE USE OF ANY PRODUCT.

• The use of optical instruments with

this product will increase eye hazard.

• Should any solid object or liquid fall

into the cabinet, unplug the deck and
have it checked by qualified
personnel before operating it any
further.

• Before operating the deck, check that

the operating voltage of the deck is
identical with your local power
supply.  The operating voltage is
indicated on the nameplate at the rear
of the deck.

• If you are not going to use the deck

for a long time, be sure to disconnect
the deck from the wall outlet.  To
disconnect the AC power cord, grasp
the plug itself;  never pull the cord.

•  The mains switch is located on the

rear exterior.

• AC power cord must be changed only

at the qualified service shop.

Do not install the appliance in a
confined space, such as a bookcase or
built-in cabinet because the mains
power switch (MAIN POWER) is
located on the rear exterior.