Sony mhc-dp900d User Manual

GB

Before operating the unit, check that the operating
voltage of your unit is identical with the voltage of
your local power supply.

• The unit is not disconnected from the AC power

source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.

• Unplug the unit from the wall outlet (mains) if it is

not to be used for an extended period of time. To
disconnect the cord (mains lead), pull it out by the
plug. Never pull the cord itself.

• Should any solid object or liquid fall into the

component, unplug the unit and have the
component checked by qualified personnel before
operating it any further.

• The AC power cord must be changed only at a

qualified service shop.

• Do not place the unit in an inclined position.
• Do not place the unit in locations where it is:

— extremely hot or cold.
— dusty or dirty.
— very humid.
— vibrating.
— subject to direct sunlight.

• Although the unit heats up during operation, this is

not a malfunction.

• Place the unit in a location with adequate

ventilation to prevent heat build-up in the unit.

If you continuously use this unit at a large volume,
the cabinet temperature of the top, side and bottom
rises considerably. To avoid burning yourself, do not
touch the cabinet.
To prevent a malfunction, do not cover the ventilation
hole for the cooling fan.

• If the unit is brought directly from a cold to a warm

location, or is placed in a very damp room, moisture
may condense on the lens inside the DVD player.
Should this occur, the unit will not operate properly.
Remove the disc and leave the unit turned on for
about an hour until the moisture evaporates.

• When you move the unit, take out any discs.
If you have any questions or problems concerning the
unit, please consult your nearest Sony dealer.

• Before playing, clean the disc with a cleaning cloth.

Wipe the disc from the center out.

• Do not use solvents such as benzene, thinner,

commercially available cleaners or anti-static spray
intended for vinyl LPs.

• Do not expose the disc to direct sunlight or heat

sources such as hot air ducts, nor leave it in a car
parked in direct sunlight.

• Do not use discs encircled with a protection ring.

This may cause a malfunction to the system.

• When using discs that have glue or similar tacky

substance on the label side of the disc or that used a
special ink when the label was printed, there is a
chance that the disc or label may become attached
to parts inside this unit. When this occurs, it may
not be possible to remove the disc, and may also
cause this unit to malfunction. Be sure to check that
the label side of the disc is not sticky before using.
The following types of disc should not be used:
— Rental or used discs with attached seals where

the glue extends beyond the seal. The perimeter
of the seal on the disc is tacky.

— Discs that have labels printed using a special ink

that feels tacky when touched.

• Discs with non-standard shapes (e.g., heart, square,

star) cannot be played on this unit. Attempting to do
so may damage the unit. Do not use such discs.

Discs recorded on CD-R/CD-RW drives may not be
played back because of scratches, dirt, recording
condition or the drive's characteristics. Besides, the
discs, which are not yet finalized at the end of
recording, cannot be played back.

Use a soft cloth slightly moistened with mild
detergent solution.