Sony LBT-ZTX7 User Manual

• Refer to General item “There is no 

sound.” (page 42) and check the 
condition of the system.

• Connect the component properly 

(page 12) while checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all 

the way.

• Turn on the connected component.
• Refer to the operating instructions 

supplied with the connected component 
and start playing.

If the system still does not operate 
properly after performing the above 
measures or other troubles not described 
above occur, reset the system as follows:
Use the buttons on the unit for the 
operation.

Unplug the power cord.

Plug the power cord back in.

Press "/1 to turn on the system.

Press x, DELAY and "/1 at the 
same time.
“COLD RESET” appears in the 
display.

The system is reset to the factory settings.  
You need to readjust all the settings you 
made, such as the preset stations, clock 
and timer.

One of the following messages may 
appear or flash in the display during 
operation.

There is no disc on the disc tray or you 
have loaded a disc that cannot be played 
back on this system.

You cannot record onto the tape because 
the tab has been removed from the tape.

There is no tape in the tape deck.

You have pressed a button those operation 
is not allowed or invalid at that time.

The on time and off time of Play Timer or 
Recording Timer is the same.

PUSH SELECT!
You tried to set the clock or timer during 

timer operation.

You have pressed PLAY MODE on the 
remote during playback.

The system is reading information of the 
disc. Some buttons are not available.

You have cleared all the steps you 
programmed.

You have reached the end of the disc 
while pressing M during playback or 
pause.

You tried to program more than 25 steps.