Sony MKS-2010 User Manual
Ch
ap
te
ap
te
r
6
A
d
A
d
v
a
nc
ed
O
p
ed
O
p
er
at
io
ns
125
Snapshots
Saving Snapshots
1
Set up the state that you want to save as a snapshot.
2
Press the [SNAPSHOT] button, turning it on.
The Flexi Pad control block enters snapshot operation
mode.
mode.
3
Press and light the region selection button for the
region which you want to save.
region which you want to save.
[M/E] button: Selects the M/E region.
[PP/ALL] button: Selects all regions.
[PP/ALL] button: Selects all regions.
4
Press the [BANK SEL] button, turning it on.
The display on the memory recall buttons changes to
the state shown in the above figure. You can now
select the save destination bank.
Banks are the 99 registers divided into 10 groups. The
following table shows the correspondences bank
numbers and register numbers.
the state shown in the above figure. You can now
select the save destination bank.
Banks are the 99 registers divided into 10 groups. The
following table shows the correspondences bank
numbers and register numbers.
5
Press a memory recall button to select a bank.
The most significant digit in the numeric display
shows the number of the selected bank.
This is also indicated by the display on the memory
recall buttons. For example, the display is as shown
below when bank 3 is selected.
shows the number of the selected bank.
This is also indicated by the display on the memory
recall buttons. For example, the display is as shown
below when bank 3 is selected.
6
Press the [STORE] button, turning it on.
The snapshot can now be saved.
7
Press the memory recall button corresponding to
register in which you want to save the snapshot.
register in which you want to save the snapshot.
Note
The contents of the corresponding register are
overwritten if you press a button which is lit in orange
or yellow.
overwritten if you press a button which is lit in orange
or yellow.
The pressed button lights in yellow when the saving of
the snapshot is finished.
The numeric display shows the selected bank number,
followed by the register number.
For example, if you selected register 37, the display
shows “3-37.”
the snapshot is finished.
The numeric display shows the selected bank number,
followed by the register number.
For example, if you selected register 37, the display
shows “3-37.”
Bank number
Register number
Bank 0
1 to 10
Bank 1
11 to 20
Bank 2
21 to 30
Bank 3
31 to 40
Bank 4
41 to 50
Bank 5
51 to 60
Bank 6
61 to 70
Bank 7
71 to 80
Bank 8
81 to 90
Bank 9
91 to 99
7
5,8
4
6
3
2
EFF/
WIPE
SNAP
SHOT
SHOT
PP/
ALL
BANK
SEL
TRANS
RATE
M/E
MCRO
STORE
7
8
9
4
5
6
1
2
3
0
EFF
DISS
AUTO
TRNS
TRNS
37
38
39
34
35
36
31
32
33
40
EFF
DISS
AUTO
TRNS
TRNS