Sony MKS-2017 User Manual
Ch
ap
te
ap
te
tem Set
tings
169
Other Settings
M/E PGM, PGM, PGM Clean, AUX1 to AUX4, and
Edit PVW
Edit PVW
• To make through mode effective, it is also necessary
to set input side through mode to “Enable” (see page
166).
166).
In an HD system, to crop the image in 4:3
mode
mode
1
From the top menu, select Setup/Diag >Input/Output
>Output Crop.
>Output Crop.
The Output Crop menu appears. The status area shows
the output port numbers, and for each port the assigned
output signal, and 4:3 crop mode setting.
the output port numbers, and for each port the assigned
output signal, and 4:3 crop mode setting.
2
Select the output port number for which you want to
make the setting.
make the setting.
• Press directry on the list in the status area.
• Use the arrow buttons to scroll the reverse video
• Use the arrow buttons to scroll the reverse video
cursor.
• Turn the knob.
a) Values 5 to 8 are only valid when the MKS-2110M (option) is
installed.
The selected output port number appears in reverse
video.
video.
3
Press [4:3 Crop].
This toggles the 4:3 crop mode on and off, and the [4:3
Crop] column in the status area shows the setting as
follows.
Indication when enabled: On
Indication when disabled: blank
Crop] column in the status area shows the setting as
follows.
Indication when enabled: On
Indication when disabled: blank
Note
When the HD system screen aspect ratio is set to 16:9
(see page 154) in the Setup/Diag >Format menu or
when your system is set to an SD format (see page
153), it is not possible to enable the 4:3 crop mode.
(see page 154) in the Setup/Diag >Format menu or
when your system is set to an SD format (see page
153), it is not possible to enable the 4:3 crop mode.
Setting the reference output
1
From the top menu, select Setup/Diag >Input/Output
>Ref Out.
>Ref Out.
The Reference Out menu appears. The status area
shows the reference output phase parameters (Line,
Time).
shows the reference output phase parameters (Line,
Time).
2
Press [Phase].
3
Turn the knobs to adjust the parameters.
Making safe title settings
This procedure allows you to set up safe title output. To
actually execute safe title output, you need to turn on safe
title output in the Enable/Safe Title menu.
actually execute safe title output, you need to turn on safe
title output in the Enable/Safe Title menu.
For details about operation, see “Safe Title” (page 134).
1
From the top menu, select Setup/Diag >Input/Output
>Safe Title.
>Safe Title.
The Safe Title menu appears. The status area shows
the output port numbers, the output signal assigned to
each port, and the markers set for each port.
the output port numbers, the output signal assigned to
each port, and the markers set for each port.
2
Using any of the following methods, select the output
port number for which you want to make the setting.
port number for which you want to make the setting.
Knob
Description
Setting
values
values
1 (No)
Output port number selection
1 to 8
a)
Knob
Description
Setting values
1 (Line)
Number of lines
–90 to +90
2 (Time)
Time
–32.00 to +96.00