Sony MHC-RG170 User Manual

Page of 44
2
GB
To reduce the risk of fire or electric shock, 
do not expose this apparatus to rain or 
moisture.
To reduce the risk of fire, do not cover the ventilation 
of the apparatus with newspapers, tablecloths, curtains, 
etc. And do not place lighted candles on the apparatus. 
To reduce the risk of fire or electric shock, do not place 
objects filled with liquids, such as vases, on the 
apparatus.
Connect the unit to an easily accessible AC outlet. 
Should you notice an abnormality in the unit, disconnect 
the main plug from the AC outlet immediately.
Do not install the appliance in a confined space, such 
as a bookcase or built-in cabinet.
This appliance is 
classified as a CLASS 1 
LASER product. This 
marking is located on the 
rear exterior.
Don’t throw away the battery with 
general house waste, dispose of it 
correctly as chemical waste.
NOTICE FOR THE CUSTOMERS IN THE U.S.A.
This symbol is intended to alert the 
user to the presence of uninsulated 
“dangerous voltage” within the 
product’s enclosure that may be of 
sufficient magnitude to constitute a 
risk of electric shock to persons.
This symbol is intended to alert the 
user to the presence of important 
operating and maintenance (servicing) 
instructions in the literature 
accompanying the appliance.
CAUTION
The use of optical instruments with this product will 
increase eye hazard.
WARNING
This equipment has been tested and found to comply 
with the limits for a Class B digital device, pursuant to 
Part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful 
interference in a residential installation. This 
equipment generates, uses, and can radiate radio 
frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful 
interference to radio communications. However, there 
is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause 
harmful interference to radio or television reception, 
which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and 
receiver.
– Connect the equipment into an outlet on a circuit 
different from that to which the receiver is 
connected.
– Consult the dealer or an experienced radio/TV 
technician for help.
This device complies with Part 15 of the FCC Rules. 
Operation is subject to the following two conditions: 
(1) this device may not cause harmful interference, and 
(2) this device must accept any interference received, 
including interference that may cause undesired 
operation. 
CAUTION
You are cautioned that any changes or modifications 
not expressly approved in this manual could void your 
authority to operate this equipment.
Note to CATV system installer:
This reminder is provided to call the CATV system 
installer’s attention to Article 820-40 of the NEC that 
provides guidelines for proper grounding and, in 
particular, specifies that the cable ground shall be 
connected to the grounding system of the building, as 
close to the point of cable entry as practical.
NOTICE FOR THE CUSTOMERS IN CANADA
CAUTION
The use of optical instruments with this product will 
increase eye hazard.
Except for European and Russian models
E
NERGY
 S
TAR
®
 is a U.S. registered 
mark. As an E
NERGY
 S
TAR
®
 partner, 
Sony Corporation has determined that 
this product meets the E
NERGY
 S
TAR
®
guidelines for energy efficiency.
MPEG Layer-3 audio coding technology and patents 
licensed from Fraunhofer IIS and Thomson.
WARNING