Sony pfm-42b2e User Manual

15

 (GB)

Connections

Within 10 mm (

13

/

32

 inch)

Within 10 mm (

13

/

32

 inch)

When you connect a cable to any of the terminals
listed below, attach the ferrite core provided before
using the cable.
AUDIO (INPUT1)
AUDIO (INPUT2)
AUDIO OUT
REMOTE
Y/C IN (VIDEO)
AUDIO IN (VIDEO)

Attach the ferrite core (black) to the end of the
cable closer to the PFM-42B2/42B2E, closing it
firmly until your hear it click.

Wind the stopper round the cord so that the ferrite
core does not slide.

Tighten the stopper and cut the surplus.

• When you connect this unit to various pieces of

equipment using the RGB/YUV connectors, use the
specified cable.
SMF-400 (D-Sub 15P - 5 BNC)
SMF-410 (D-Sub 15P - D-Sub 15P)

• You are cautioned that this unit will not be in

compliance with the EMC limits unless the ferrite
core is installed on the interconnecting wire.

• First make sure that the power to each piece of

equipment is turned off.

• Use connecting cables suitable for the equipment to

be connected.

• The cable connectors should be fully inserted into

the jacks. A loose connection may cause hum and
other noise.

• To disconnect the cable, pull it out by grasping the

plug. Never pull the cable itself.

• Refer to the instruction manual of the equipment to

be connected.

• Insert the plug securely into the AC IN socket.
• Use one of the two AC plug holders (supplied) that

will securely hold the AC plug.