Sony RHTG2000 User Manual
26
US
Sound is interrupted or there is noise.
• Check that you are not inputting PCM 96 kHz audio
signals; this system cannot output PCM 96 kHz audio
signals.
signals.
There is no picture or an unclear picture appears on the TV
screen.
screen.
• You have set progressive format on your DVD player but
your TV cannot accept the signal in progressive format.
In this case, return the setting to interlace format on your
DVD player. For details, refer to the operating
instructions supplied with your DVD player.
In this case, return the setting to interlace format on your
DVD player. For details, refer to the operating
instructions supplied with your DVD player.
• Even if your TV is compatible with progressive format
(525p/625p) signals, the image may be affected when
you set progressive format on your DVD player. In this
case, return the setting to interlace format on your DVD
player. For details, refer to the operating instructions
supplied with your DVD player.
you set progressive format on your DVD player. In this
case, return the setting to interlace format on your DVD
player. For details, refer to the operating instructions
supplied with your DVD player.
• Check that the TV is selected correctly.
• Set the TV to the appropriate input mode.
• Set the TV to the appropriate input mode.
TUNER
Radio stations cannot be tuned in.
• Check that the antennas are connected securely.
• Adjust the angles of the antennas.
• Connect an external antenna if necessary.
• Use manual tuning.
• No stations have been preset or the preset stations have
• Adjust the angles of the antennas.
• Connect an external antenna if necessary.
• Use manual tuning.
• No stations have been preset or the preset stations have
been cleared (when tuning by scanning preset stations).
Preset the stations.
Preset the stations.
FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied) to connect the
receiver to an outdoor FM antenna as shown below. If
you connect the receiver to an outdoor antenna, ground it
against lightning. To prevent a gas explosion, do not
connect the ground wire to a gas pipe.
you connect the receiver to an outdoor antenna, ground it
against lightning. To prevent a gas explosion, do not
connect the ground wire to a gas pipe.
OTHER
The remote does not function.
• Point the remote at the remote sensor
on the system.
• Remove any obstacles in the path between the remote and
the system.
• Replace both batteries in the remote with new ones, if
they are weak.
• Make sure you select the correct input on the remote.
If the system still does not operate
properly after performing the above
measures, reset the system as follows:
properly after performing the above
measures, reset the system as follows:
Use buttons on the unit for the operation.
1
Press ?/1 to turn on the power.
2
Press INPUT SELECTOR, VOLUME –, ?/1 at the
same time.
same time.
“COLD RESET” appears and the system is reset. AMP
menu, sound field and the preset radio stations, etc.,
return to the default settings.
menu, sound field and the preset radio stations, etc.,
return to the default settings.
ANTENNA
AM
COAXIAL
FM
75