Sony rdr-gx120 User Manual

Page of 88
77
A
d
d
iti
o
n
a
l I
n
fo
rm
a
tio
n
Notes About This 
Recorder
On operation
• If the recorder is brought directly from a 
cold to a warm location, or is placed in a 
very damp room, moisture may condense 
on the lenses inside the recorder. Should 
this occur, the recorder may not operate 
properly. In this case, if the recorder is on, 
leave it on (if it is off, leave it off) for about 
an hour until the moisture evaporates.
• When you move the recorder, take out any 
discs. If you don’t, the disc may be 
damaged.
On adjusting volume
Do not turn up the volume while listening to 
a section with very low level inputs or no 
audio signals. If you do, the speakers may be 
damaged when a peak level section is played.
On cleaning
Clean the cabinet, panel, and controls with a 
soft cloth slightly moistened with a mild 
detergent solution. Do not use any type of 
abrasive pad, scouring powder or solvent 
such as alcohol or benzine.
On cleaning discs, disc/lens cleaners
Do not use a commercially available 
cleaning disc or disc/lens cleaner (wet or 
spray type). These may cause the recorder 
to malfunction.
Notes about the discs
• To keep the disc clean, handle the disc by its 
edge. Do not touch the surface. Dust, 
fingerprints, or scratches on the disc may 
cause it to malfunction.
• Do not expose the disc to direct sunlight or 
heat sources such as hot air ducts, or leave 
it in a car parked in direct sunlight as the 
temperature may rise considerably inside 
the car.
• After playing, store the disc in its case.
• Clean the disc with a cleaning cloth. Wipe 
the disc from the centre out.
• Do not use solvents such as benzine, 
thinner, commercially available cleaners, or 
anti-static spray intended for vinyl LPs.
• Do not use the following discs.
– A disc that has a non-standard shape (e.g., 
card, heart).
– A disc with a label or sticker on it.
– A disc that has cellophane tape or sticker 
adhesive on it.
On replacement of parts
In the event that this unit is repaired, repaired 
parts may be collected for reuse or recycling 
purposes.