Sony RM-PP401 User Manual

13

You can program the remote to control non-Sony
components.  Once the control signals have been
memorized, you can use those components as part of your
system.
Furthermore, you can also program this remote for Sony
components that the remote is unable to control.  Note
that the remote can control the components that accept
infrared wireless control signals only.

Press IR SET.
The program indicator lights up.

Press the function button for the component you
want to control (except the 5.1 IN buttons).
For example, if you are going to control a CD player,
press CD.

Press the numeric buttons to enter the numeric
code (or one of the codes if more than one code
exist) corresponding to the component and the
make of the component you want to control.
See the tables on pages 14 and 15 for information on
the numeric code(s) corresponding to the component
and the make of the component.

Press ENTER D.TUNING.
When the program indicator goes off, the
component(s) can then be controlled using this
remote.

z

• If the program indicator does not light up, the batteries are

weak.  Replace both batteries.

• If you do not do Step 3 within one minute after pressing the IR

SET button in Step 2, the remote automatically exits learning
mode.  Start again from Step 2.

• Programmed components will not turn on when you press a

function button.  You have to turn on the component’s power
switch.

• The numeric codes are based on the latest information available

for each brand.  There is a chance, however, that your
component will not respond to some or all of the codes.

• All of the functions on this remote may not be available when

used with your particular component.

To clear all the programmed signals, do the following
procedure.  The remote is reset to its factory-setting.

1/u,