Sony SAITE1300-F User Manual

Package Contents / Setting the Loop ID (SAITe1300-F only)

17

After opening the package, make sure that all the 
following items are present.
Contact your dealer if anything is missing.

• S-AIT Tape Drive Unit (1)
• S-AIT Data Cartridge SAIT1-500 (1)
• S-AIT Cleaning Cartridge SAIT1-CL (1) 
• Air filter unit (1)
• Quick start guide (1)
• CD-ROM  (1)

(containing the operating instructions and device 
drivers)

• SCSI terminator (1) (SAITe1300-S only)

• In addition to the above, other items may be included 

in the package.

• All the items included with the S-AIT Tape Drive unit 

are indicated on the package.

Refer to the “Operating Instructions” (PDF) and 
perform the data compression settings using the DIP 
switches at the bottom of the S-AIT Tape Drive Unit.

The default settings of the DIP switches is as follows.
• DC  Control-1:  ON

Compression is enabled.

• DC  Control-2:  OFF

The host can control compression.

If necessary, perform the SCSI ID settings using the 
SCSI ID switches on the rear of the S-AIT Tape Drive 
Unit.
The default SCSI ID of the SAITe1300-S is 0. (The unit 
can be configured to SCSI ID addresses ranging from 0 
to 15.)
For details, refer to the “Operating Instructions” (PDF). 

If necessary, perform the Loop ID settings using the loop 
ID jumpers on the rear of the S-AIT Tape Drive Unit. 
These jumpers are functional when the topology is 
arbitrated loop. 
For details, refer to the “Operating Instructions” (PDF).