Sony SNCDH110W User Manual

CGI Command Manual   

25 

This parameter is suitable for the pan and tilt operation which a joy sticks was used for. 

 

This value can be specified with one step within the range from -100 to 100. It moves to the right side 

when a positive value is specified, and when a negative value is specified, it moves to the left side. Pan 

operation stops when 0 is specified. The speed is almost directly proportional according to the value. 

Actual speed changes according to the zoom position. When the value is 100 on the Wide edge, speed 

becomes 120 degree/sec. When this value and <tilt speed> are omitted at the same time, present 

operation is maintained about pan and tilt operation. 

 

This value can be specified with one step within the range from -100 to 100. It moves to the upper side 

when a positive value is specified, and when a negative value is specified, it moves to the lower side. Tilt 

operation stops when 0 is specified. The speed is almost directly proportional according to the value. 

Actual speed changes according to the zoom position. When the value is 100 on the Wide edge, speed 

becomes 60 degree/sec. When this value and <pan speed> are omitted at the same time, present 

operation is maintained about pan and tilt operation. 

 

This value can be specified with one step within the range from -100 to 100. It moves to the Tele 

direction when a positive value is specified, and when a negative value is specified, it moves to the Wide 

direction. Zoom operation stops when 0 is specified. When this value is omitted at the same time, 

present operation is maintained. 

 

You should send the next command after waiting for HTTP response "204 No Content" from the camera. 

When you do not wait for the response, you should send the next command after it waits at the time of 

the value of "ContinuousPanTiltZoomInterval" obtained by using system information inquiry 

"/command/inquiry.cgi&inq=system". The unit of "ContinuousPanTiltZoomInterval" is ms. Send 

"ContinuousPanTiltZoom=0,0,0" at once regardless of the above-mentioned when you stop PTZ 

operation of camera. Except for LAN environment, moving command and stopping command might be 

reversed, and the camera doesn't stop. In this case, wait for the HTTP response from the camera to 

guarantee order. 

 

When using "ContinuousPanTiltZoom" parameter, reconnect every time the command is sent. The 

reaction of the PTZ operation worsens if keeping connection.