Sony SSF6000 User Manual

• Before connecting, turn off the amplifier or receiver to

avoid damaging the speaker system.

• This speaker system is driven best by an amplifier or

receiver rated as per the wattage indicated in the
specification section.
A low-powered amplifier or receiver could result in
signal clipping, which could result in tweeter burn-out.
Therefore, it is recommended to use an amplifier or
receiver with sufficient power rating.

Note
Avoid driving the speaker system continuously with a
wattage exceeding the maximum input power of each
speaker.

• Do not attempt to open the enclosure or remove

speaker units. There are no user-serviceable parts
inside.

• Keep recorded tapes, watches, and personal credit

cards using magnetic coding away from the speaker
system.

• Periodically wipe the cabinet with a soft cloth. Do not

use any type of scouring powder, abrasive pad or
solvent.

• Be sure to install the grill net in the correct direction.

Please note that room acoustics can often produce large
difference in the sound for small changes in speaker
placement.
• Set your speaker system on a floor which is hard, flat

place.

• Place the speaker system against a hard wall with its

back about 10 cm (4 in.) away from a wall. The
proportion of bass increases as you move a speaker
close to intersecting room surfaces (wall and wall, etc.).

• Place the right and left speakers in a similar acoustic

environment.

• It is recommended that the speaker/listener

relationship be an equilateral triangle.

Speaker system

4-way, magnetically shielded

Speaker units

Woofer (Mid Bass): 20 cm (8 in.),
cone type
Woofer (Low Bass): 20 cm (8 in.),
cone type
Midrange: 8 cm (3 

1

/

4

 in.), cone type

Tweeter: 2.5 cm (1 in.), balanced dome
type

Enclosure type

Bass reflex

Rated impedance

8 ohms

–

+

Power handling capacity

Maximum input power:  200 watts

Sensitivity level

90 dB (1 W, 1 m )

Frequency range

35 Hz - 50,000 Hz

Dimensions (w/h/d) Approx. 290 

× 1,065 × 303 mm

(11 

1

/

2

 

× 42 × 12 in.) including front

grille

Mass

Approx. 15 kg (33 lb 2 oz)

Supplied accessory

Speaker cord (2)

Speaker system

4-way, magnetically shielded

Speaker units

Woofer (Mid Bass):  16 cm (6 

3

/

8

 in.),

cone type
Woofer (Mid Low):  16 cm (6 

3

/

8

 in.),

cone type
Midrange: 8 cm (3 

1

/

4

 in.), cone type

Tweeter: 2.5 cm (1 in.), balanced dome
type

Enclosure type

Bass reflex

Rated impedance

8 ohms

Power handling capacity

Maximum input power:  180 watts

Sensitivity level

89 dB (1 W, 1 m )

Frequency range

40 Hz - 50,000 Hz

Dimensions (w/h/d) Approx. 215 

× 950 × 260.5 mm

(8 

1

/

2

 

× 37 

1

/

2

 

× 10 

3

/

8

 in.) including

front grille

Mass

Approx. 12.2 kg (26 lb 15 oz)

Supplied accessory

Speaker cord (2)

Speaker system

3-way, magnetically shielded

Speaker units

Woofer: 20 cm (8 in.), cone type
Midrange: 8 cm (3 

1

/

4

 in.), cone type

Tweeter: 2.5 cm (1 in.), balanced dome
type

Enclosure type

Bass reflex

Rated impedance

8 ohms

Power handling capacity

Maximum input power:  150 watts

Sensitivity level

88 dB (1 W, 1 m )

Frequency range

45 Hz - 50,000 Hz

Dimensions (w/h/d) Approx. 240 

× 850 × 263 mm

(9 

1

/

2

 

× 33 

1

/

2

 

× 10 

3

/

8

 in.) including

front grille

Mass

Approx. 11.3 kg (24 lb 15 oz)

Supplied accessory

Speaker cord (2)

Design and specifications are subject to change without
notice.

 2007 Sony Corporation   

Printed in Malaysia

2-899-179-11(1)

Owner’s Record

The model and serial numbers are located on the rear of the unit. Record the
serial number in the space provided below. Refer to them whenever you call
upon your Sony dealer regarding this product.

Model No.

Serial No.

(1)