Sony STR-DH510 User Manual

The table below shows the display when 
measurement starts.

* The corresponding speaker indicator lights 

up in the display during measurement.

When measurement ends, “COMPLETE” 
appears on the display and the settings are 
registered.

• Operations other than turning the receiver on or off 

are deactivated during the measurement.

• The measurements may not be performed correctly 

or Auto Calibration cannot be performed when 
special speakers, such as dipole speakers are used.

The Auto Calibration function will be 
canceled when you do the following during 
the measurement process: 
– Press ?/1 
– Press MUTING (RM-AAU071 only) or 

 

 

(RM-AAU074 only)

– Press the input buttons or turn INPUT 

SELECTOR on the receiver.

– Change the volume level.
– Connect the headphones.

Disconnect the optimizer microphone from the 
AUTO CAL MIC jack.

• Auto Calibration cannot detect the subwoofer. 

Therefore, all subwoofer settings will be 
maintained.

• If you have reposition your speaker, we 

recommend that you perform Auto Calibration 
again to enjoy the surround sound.

When an error is detected during Auto 
Calibration, an error code will appear on the 
display cyclically after each measurement 
process as follows:
Error code 

t blank display t (error code t 

blank display)

a)

 

t PUSH t blank display 

t ENTER

a)

Appears when there are more than one error code.

Record down the error code.

Press .

Press ?/1 to turn off the receiver.

Rectify the error.
For details, see “Error codes and remedies” 
below.

Turn on the receiver and perform Auto 
Calibration again (page 31).

Environment noise 
level

NOISE.CHK

Speaker connection MEASURE and SP 

DET. appears 
alternately*

Speaker level

MEASURE and GAIN 
appears alternately*

Speaker distance

MEASURE and 
DISTANCE appears 
alternately*