Sony STR-DA3200ES User Manual

Page of 127
117
GB
Ad
diti
onal
 Inf
o
rma
tion
• Do not place the receiver near equipment 
such as a television, VCR, or tape deck. (If 
the receiver is being used in combination 
with a television, VCR, or tape deck, and is 
placed too close to that equipment, noise 
may result, and picture quality may suffer. 
This is especially likely when using an 
indoor antenna (aerial). Therefore, we 
recommend using an outdoor antenna 
(aerial).)
On operation
Before connecting other components, be sure 
to turn off and unplug the receiver.
On cleaning
Clean the cabinet, panel, and controls with a 
soft cloth slightly moistened with a mild 
detergent solution. Do not use any type of 
abrasive pad, scouring powder, or solvent, 
such as alcohol or benzine.
If you have any questions or problems 
concerning your receiver, please consult your 
nearest Sony dealer.
Troubleshooting
If you experience any of the following 
difficulties while using the receiver, use this 
troubleshooting guide to help you remedy the 
problem. Should any problem persist, consult 
your nearest Sony dealer.
Audio
There is no sound, no matter which 
component is selected, or only a very 
low-level sound is heard.
• Check that the speakers and components 
are connected securely.
• Check that all speaker cords are connected 
correctly.
• Check that both the receiver and all 
components are turned on.
• Check that MASTER VOLUME control is 
not set at –
∞ dB.
• Check that SPEAKERS (OFF/A/B/A+B) 
is not set to “OFF” (page 42).
• Press MUTING on the remote to cancel 
the muting function.
• Check that you have selected the correct 
component with INPUT SELECTOR.
• Check that headphones are not connected.
• When only a very low-level sound is 
heard, check to see if NIGHT MODE is 
activated (page 78).
• The protective device on the receiver has 
been activated. Turn off the receiver, 
eliminate the short-circuit problem, and 
turn on the power again.
There is no sound from a specific 
component.
• Check that the component is connected 
correctly to the audio input jacks for that 
component.
• Check that the cord(s) used for the 
connection is (are) fully inserted into the 
jacks on both the receiver and the 
component.
continued