Sony STR-DE197 User Manual

Page of 32
masterpage:Left
lename[C:\Documents and 
Settings\pc13\Desktop\JC060000_4253437131DE197_GB\4253437131\GB07ADD_STR-
DE197-CEL.fm]
 model name1[STR-DE197]
 [4-253-437-13(1)]
26
GB
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC 
DISTORTION:
 
(Models of area code U only)
With 8 ohm loads, both channels driven, from 
 
20 – 20,000 Hz; rated 100 watts per channel 
minimum RMS power, with no more than 
0.09% total harmonic distortion from 250 
milliwatts to rated output.
Amplifier section
Power Output
Models of area code U, CA
Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
 125 W + 125 W
1)
Models of area code CEL, CEK
Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
 100 W + 100 W
1)
1) Measured under the following conditions:
Frequency response
Inputs (Analog)
2) INPUT SHORT (with bass boost and tone 
bypassed).
3) Weighted network, input level.
Outputs (Analog)
Bass Boost:
+8 dB at 70 Hz
Tone:
±10 dB at 100 Hz and 
 
10 kHz
FM tuner section
Tuning range
87.5 – 108.0 MHz
Antenna
FM wire antenna
Antenna terminals
75 ohms, unbalanced
Intermediate frequency
10.7 MHz
Sensitivity
Mono:
18.3 dBf, 2.2 µV/75 ohms
Stereo:
38.3 dBf, 22.5 µV/75 ohms 
Useable sensitivity
11.2 dBf, 1 µV/75 ohms
S/N
Mono: 76 
dB
Stereo: 70 
dB
Harmonic distortion at 1 kHz
Mono: 0.3%
Stereo: 0.5%
Separation
45 dB at 1 kHz
Frequency response
30 Hz – 15 kHz, 
 
+0.5/–2 dB
Selectivity
60 dB at 400 kHz
AM tuner section
Tuning range
Models of area code U, CA
With 10-kHz tuning scale:  530 – 1,710 kHz
4)
With 9-kHz tuning scale:  531 – 1,710 kHz
4)
Models of area code CEL, CEK
With 9-kHz tuning scale:  531 – 1,602 kHz
Antenna
Loop antenna
Intermediate frequency
450 kHz
Usable sensitivity
50 dB/m (at 1,000 kHz or 
999 kHz)
S/N
54 dB (at 50 mV/m)
Harmonic distortion
0.5% (50 mV/m, 400 Hz)
Selectivity
At 9 kHz:
35 dB
At 10 kHz:
40 dB
4) You can change the AM tuning scale to 9 kHz or 10 
kHz. After tuning in any AM station, turn off the 
receiver. While holding down PRESET TUNING +, 
press ?/1. All preset stations will be erased when 
you change the tuning scale. To reset the scale to 10 
kHz (or 9 kHz), repeat the procedure.
Specifications
Area code
Power requirements
U, CA
120 V AC, 60 Hz
CEL, CEK
230 V AC, 50 Hz
CD, MD/TAPE, 
 
VIDEO 1, 2
20 Hz – 50 kHz
 
+0/–0.5 dB (with bass 
boost and tone bypassed)
CD, MD/TAPE, 
 
VIDEO 1, 2
Sensitivity: 500 mV
 
Impedance: 50 kiloohms
 
S/N
2)
: 85 dB
 
(A, 500 mV
3)
)
MD/TAPE (OUT), 
 
VIDEO 1 (AUDIO OUT)
Voltage: 500 mV
 
Impedance: 10 kiloohms
GB01COV_STR-DE197-CEL.book  Page 26  Thursday, May 25, 2006  9:37 AM