Sony str-lsa1 User Manual

24

Using the Sleep Timer Z

You can set the receiver to turn off automatically at a
specified time.

Press SLEEP on the remote while the power is on.
“SLEEP” lights up in the display.
Each time you press SLEEP, the time display changes as
shown below.

t

  2:00 t  1:30 t  1:00   t  0:30   t  0:20   t  0:10  t OFF

After you specified the time, the display goes back the
status before you pressed the SLEEP button.

To check the remaining time before the receiver
turns off
Press SLEEP.  The remaining time appears in the display.

To cancel the Sleep Timer
Press SLEEP again while the remaining time appears.
“OFF” appears in the display and the Sleep Timer is
canceled.

z

When the receiver turns off, the corresponding i.LINK
component turns off automatically at the same time.

By using the i.LINK Control function, operations on the
receiver can be automatically linked with the kperation of
specific components.

When i.LINK Control is turned on, the following
operations are linked:
• When you press the CD N button or MD N button on

the remote, the receiver and the corresponding
component turn on and the component starts to play.

• When the N button on the CD player or MD deck is

pressed to start playback, or the CD N button or MD
N button on the remote of the receiver is pressed, the
respective component is automatically selected as the
program source.

• When the display brightness on the receiver is changed,

the same change occurs to the brightness level of the
displays on the MDS-LSA1 MD Deck or CDP-LSA1 CD
Player.

• When Sleep Timer turns off the receiver, the

corresponding i.LINK component also turns off.

• When you turn the receiver on or off, the corresponding

i.LINK component also turns on or off.

• When the i.LINK MD deck or CD player is selected and

no operation has been done on the receiver for more
than one minute, the receiver turns off automatically
when you turn off the selected i.LINK component.
However, when the Sleep Timer is activated, the
receiver won’t turn off until the specified time elapses.

To turn off the i.LINK Control function
Do the procedure above, selecting “Off” in step 3.

• The i.LINK Control functions described above may not work

properly on certain components and under certain conditions.

• Make sure i.LINK Control is active on only one component

within the i.LINK configuration.  For example, when two STR-
LSA1s are hooked up in the same configuration, turn on the
i.LINK Control function on only one receiver and not the other.