Sony trinitron pvm-14l2 User Manual

Troubleshooting

30

The REMOTE menu is used to assign the functions to 
the pins of the PARALLEL REMOTE terminal.
Pin 1 to 4 and pin 6 to 8 can be used. The following lists 
the functions you can assign to the pins.
• – –  (No function is assigned.)
• LINE  A
• LINE  B
• RGB/COMP (for the PVM-14L2/PVM-20L2 only)
• OPTION  A
• OPTION  B
• TALLY
• UNDERSCAN
• 16:9
• EXT SYNC
• BLUE ONLY
• DEGAUSS

If you use the parallel remote function, you need to 
connect cables. 

The OPTION CONFIG menu is used to set the optional 
board installed in the option slot on the rear panel. 
Depending on the board installed, the screen displayed 
may differ. If no board is installed, the item settings are 
not displayed. After assigning the input signal, be sure to 
adjust the monitor’s AUTO CHROMA/PHASE.

The following lists the abbreviations in the menu and their full 
names:
• CP-TC1:

SMPTE 331M System Item USER DATE/TIME 
STAMP

• CP-TC2:

SMPTE 331M System Item CREATION DATE/
TIME STAMP

• ES-TC1:

SMPTE 328M MPEG ES Editing Information 
TIME CODE1

• ES-TC2:

SMPTE 328M MPEG ES Editing Information 
TIME CODE2

• RP188:

SMPTE RP188 Time Code

• VITC:

SMPTE 12M VITC, SMPTE 266M D-VITC

The serial number of the board is displayed on the 
OPTION CONFIG menu.

If the cooling fan in the BKM-150CP or BKM-155DV 
is stopped, the screen shows the following message in 
red “BKM-xxxxx FAN ERROR”. In this case, you 
cannot select Option A or Option B.

This section may help you isolate the cause of a problem 
and as a result, eliminate the need to contact technical 
support.
• The display is colored green or purple. 

t Select 

the correct input by pressing one of the buttons related 
to input. 

• The signal input through the RGB/COMPONENT 

input connectors does not appear on the screen (for 
the PVM-14L2/PVM-20L2 only).

 t Set RGB/

COMP SEL on the USER CONFIG menu 
appropriately according to type of input signal.

• The BKM-150CP or BKM-155DV has been 

installed. The error message “BKM-xxxxx FAN 
ERROR” is displayed and you cannot select 
Option A or Option B. 

t Repair the BKM-xxxxx.

FORMAT

Sets the signal type.
Select SDTI-CP or D1-SDI.

AUDIO

Selects an audio channel.
D1-SDI
Select from among CH1+CH2 
through CH15+CH16, or CH1 
through CH16.
SDTI-CP
Select from among CH1+CH2 
through CH7+CH8, or CH1 
through CH8.
The audio signal input to the 
OPTION AUDIO INPUT 1/2 jack 
is ignored.

TIME CODE

Selects the time code display.
D1-SDI
Select VITC, RP188 or OFF.
SDTI-CP
Select VITC, CP-TC1, CP-TC2, 
ES-TC1, ES-TC2 or OFF.

AUDIO

Selects an audio channel.
Select from among CH1+CH2,  
CH3+CH4, CH1/3, CH2/4, CH1/
3+CH2/4, or CH1 through CH4.
OPTION AUDIO INPUT 1/2 jack 
is ignored.