Sony VPL-VW200
11
Conn
ect
ion
s a
nd
ion
s a
nd
Prep
arat
ion
s
s
This section describes how to install the projector and screen, how to connect the
equipment from which you want to project the picture, etc.
equipment from which you want to project the picture, etc.
Unpacking
Check the carton to make sure it contains the following items:
Inserting the batteries into the remote control
Caution about handling the remote control
• Handle the remote control with care. Do not drop or step on it, or spill liquid of any kind
• Handle the remote control with care. Do not drop or step on it, or spill liquid of any kind
onto it.
• Do not place the remote in a location near a heat source, a place subject to direct
sunlight, or a damp room.
Connections and Preparations
• Remote control (1)
• Size AA (R6) batteries (2)
• AC power cord (1)
• ImageDirector3 CD-ROM (1)
• Plug holder
• Size AA (R6) batteries (2)
• AC power cord (1)
• ImageDirector3 CD-ROM (1)
• Plug holder
• Air filter cover (1)
• Lens cap (1)
When you have purchased the projector,
the lens cap is put onto the lens.
Remove this lens cap when you use the
projector.
the lens cap is put onto the lens.
Remove this lens cap when you use the
projector.
• Operating Instructions (this manual)
Insert the batteries E side first as shown in the illustration.
Inserting them forcibly or with the polarities reversed may
cause a short circuit and may generate heat.
Inserting them forcibly or with the polarities reversed may
cause a short circuit and may generate heat.
Push and slide to open.